M900 anti bark voice-activated stop barking collar Pet training collar dog training system  pets electronics smart collar 

        service at tendtronic dot com                       

Matching Receiver and Transmitter

1 Install the batteries and Turn on the transmitter

2.Install the batteries for the receiver.The LED inside the receiver starts to keep flashing.Press vibration or shock(PPT) button immediately.Then the LED will stop flashing and only light which indicates that mean the transmitter and the receiver have matched each other successfully.

3.If LED stops flashing on its own without press any button in the transmitter,take out the batteries.Wait for at least 10 seconds and try step 2 again.

4.Put the cover on the receiver firmly.

5.Attach the receiver to the collar.

*Bark Terminator(voice-activated collar) DO NOT need to macth

 

 

How to Check Shock

The static impulse released but the receiver can not be seen with naked eye.you have two ways to test the shock:

•Use a test light.Put the test light on both nipples in the receiver then press shock button on the transmitter .The light will flash.Remember,the test light is designed specifically for testing only and not a normal part of collar used for the dog.Please take it off this light after the test.

•Use your finger. Select the lowest level 001.(000=off) Put your fingers on both nipples in the receiver then press shock button on the transmitter .You will feel the shock.

*Blowing/Shouting against the receiver to turn on the Bark Terminator(voice-activated stop barking collar)

 

Features

•The strong static impulse can penetrate the hair of the pet and fabric within 6mm thick.It is unnecessary to let the discharging point touch the skin of the pet.

•The static impulse can quickly and effectively curb the improper deeds of the pet.

•Both the static impulse and warning functions are set with automatic stop.This is for not reprimanding the pet continuously.

•The collar receiver,it will turn on and turn off automatically to save power.

 

Note for Use:

•Most pets feel uncomfortable at first wearing the collar.Don’t use any of the functions before the pet has gotten used to the collar.

•The valid distance of transmission means the straight-line distance between the transmitter and the receiver with out obstacles in between.If there are interference signals or signal screening around,the actual transmitter distance may vary.

•This product is for pet training .Only by training let your pet understand the intention of its owner.Good effect can only be achieved after a period of training.

•Training sessions should be kept positive and short ,about 10-15 minutes long each time.

•Presently,this product is the most effective and safest tool for training pet.Following the correct operational instructions,you can effectively train the pet and bring it no harm.

•If you don’t use the collar for a long time, take the collar off your pet and take out the batteries.

 

 

                                        VIDEO            INTRODUCTION                          

                                      go to VK and search Tend Tronic