Model: | LED Strip Light |
---|---|
Brand: | N/A |
Origin: | Made In China |
Category: | Electronics & Electricity / Other Electrical & Electronic |
Label: | LED Strip Light , Silicone Tube , Waterproof |
Price: |
-
|
Min. Order: | 100 pc |
Last Online:25 Dec, 2012 |
Application:
Car Decoration
Architectural decorative lighting
Stairway
Accent lighting
Archway,canopy and bridge edge decoration.
Assembly Information
- Solder connection should only be performed on designated solder pads (marked “ +/-”). During? soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
- The smallest unit (50mm or 100mm - 3 LEDs) can be removed by cutting with scissors between the designated solder pads.
- The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partide. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).
- The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.