Model: | Rubber Flexible |
---|---|
Brand: | Liwei |
Origin: | Made In China |
Category: | Construction & Decoration / Pipe, Tube & Parts / Pipe Fittings |
Label: | rubber joint , stainless steel |
Price: |
US $1.5
/ pc
|
Min. Order: | 1 pc |
Last Online:29 Dec, 2014 |
Specifications
Rubber Flexible Joint
Since 1988
Rubber:EPDM,CR,NBR,NR,etc.
Flange:GB,ANSI B16.5, DIN2501, BS45
Agent wanted
1) Product Performance
LIWEI Rubber Flexible Joint are designed for piping systems to absorb pipe movements, relieve stress, reduce system noise/vibration, and compensate for misalignment/offset and to protect rotating mechanical equipment against start-up surge forces.
DN32-DN3600 Flexible Joint is a single sphere design with less length, the supply range is from 32mm to 3600mm, and design pressure can be 1.0MPa/1.6MPa/2.5MPa, which is always used where low cost or space limitation control.
2) Application Range
Equipped with the excellent comprehensive performances of flexible rubber joint, LIWEI Rubber Flexible Joint can be used for lift and transportation of raw water and sewage, transportation of water supply, cooling cycle water of thermal power plant, condensate water of metallurgy industry and chemical materials of chemical industries, cooling and dilution of oil and chemical industries and flexible connection of other industries.
LIWEI Rubber Flexible Joint is also suitable to transport all grain and powder material and gas for its high abrasive resistance.
In addition, special notifications are hereby conducted for design units and clients so as to ensure the project quality. Please note to install anti-break stop device, if Rubber Flexible Joint are designed to install close to pump exit nozzle and pipes’ corner. If your pipes need to be buried, please use our patent-buried protective devices. In a word, remark requirement for use, and we will provide satisfactory service to you.
3) Features and Benefits
1, Versatile hand-built construction. Made in China
2, Absorbs directional movement
3, Absorbs vibration, noise and shock
4, Compensates for misalignment
5, Wide flowing arch design
6, Virtually eliminates sediment buildup
7, Economical fully molded construction
8, High vacuum rating (up to 30" Hg) can be supplied for certain sizes
9, Special grooved flange ring design, prevent rubber end pull out
10, Solid galvanized steel floating flanges speed the installation time
11, High tensile aircraft cable is embedded in the raised face rubber ends to prevent pull out and avoids the sharp cutting edge of solid steel rings
12, No gaskets required; integrally rubber flanged design, no gaskets required, DIN PN10/16 drilling standard, other flange drilling available, including ANSI 150lb/300 lb, BS, and JIS
Note:
1. The Liwei Rubber Flexible Joint with Flanges supply range is from DN32 to DN3600.
2. Control units must be used when piping is not properly anchored.
3. The rated pressure 2.5MPa products will only be sold with control units.
4. The Liwei Rubber Flexible Joint with Flanges Pressure rating is based on 30°C operating temperature. The pressure rating is reduced at higher temperatures.
5. Movements shown in the above table are non-concurrent.
6. Normally, the flange drilling is based on DIN PN16, ANSI 150/250/300 lbs, BS PN10, JIS 10K are also available upon request.
7. Please remark the application standard of structural strength and connection size when placing an order.
8. If the relevant parameters of flexible rubber joints needed are not within the scope of the foregoing list, please remarks. We can design and manufacture on behalf of you.