Home > Products > Electronics & Electricity > Optical Fiber, Cable & Wire > Optical Fiber

LREC10GX8510-X3ATL  10G SFP+ Fiber Optic Transceiver

LREC10GX8510-X3ATL is a high performance, cost effective modules, which is optimized for 10G Ethernet, supporting data-rate of 10.3125Gbps (10GBASE-SR) or 9.953Gbps (10GBASE-SW), and transmission distance up to 300m on 50µm MMF(2000MHz·km).The transceiver consists of two sections: The transmitter section incorporates an 850nm VCSEL driver. The receiver section consists of a PIN photodiode integrated with a transimpedance preamplifier (TIA). The module is hot pl able into the 20-pin connector. 

The high-speed electrical interface is base on low voltage logic, with nominal 100 Ohms differential impedance and AC coupled in the module. The optical output can be disabled by LVTTL logic high-level input of TX_DIS. Loss of signal (RX_LOS) output is provided to indicate the loss of an input optical signal of receiver. 

A serial EEPROM in the transceiver allows the user to access transceiver monitoring and configuration data via the 2-wire SFP Management Interface. This interface uses a single address, A0h, with a memory map divided into a lower and upper area. Basic digital diagnostic (DD) data is held in the lower area while specific data is held in a series of tables in the high memory area.

Compliant with SFP+ MSA 
Compliant with IEEE 802.3ae-2002 

Compliant with FDA 21 CFR 1040.10 and 1040.11, Class I except for deviations pursuant 

RoHS compliance 

Features

Support Multi Rate 1.25-10.709Gbps 
Up to 300m transmission distance on 50µm MMF (2000MHz·km) 
850nm VCSEL and PIN receiver 
SFI electrical interface 
2-wire interface for integrated Digital Diagnostic monitoring 
SFP+ MSA package with duplex LC connector 

Hot pl able 
Very low EMI and excellent ESD protection 
+3.3V power supply 
Power consumption less than 800mW 
Operating case temperature: 0~+70 Centigrade

Applications

10GBASE-SR at 10.3125Gbps 
10GBASE-SW at 9.953Gbps 
Other optical links

Order Information:

PS: The above details are only for reference, if there is any change, no prior notice.