Home > Products > Electronics & Electricity > Electronic Instrument > Other Electronic Instrument

The principle of L2000 level switch

The working principle is based on the radio frequency (RF) capacitor technology. A radio frequency applied to the probe, through continuous analysis, determine the impact caused by the surrounding environment.Because all materials have a dielectric constant, and conductivity are different from the air, when the probe is in contact with the materials as the total impedance of small capacitance offset reflects the change.

The characteristics of L2000 level switch

Versatility: can be applied to a variety of conductive and non-conductive dielectric measurement, such as liquid,viscous, particles, powder, fly ash.

Anti adhesion: using patented anti adhesion circuit, can eliminate the false signal generated due to materialadhesion.

Probe: no detachable cable connection between the controller and the probe, at any time can be removedwithout affecting the controller replacement repair, import materials.

High temperature: suitable for -184 to 280 DEG C working environment, can provide other ceramic probesuitable for higher temperature.

Output form: double pole double throw relay signal output, and a status display output state, and have 0 to 30 seconds of delay function.

The parameters of L2000 level switch

Fault alarm: upper or lower, field adjustable.

Output relay: DPDT, 10A, 115VAC or 26VDC (resistance) or 5A, 220VAC

Delay time: 0-30 seconds adjustable (open or closed):

Supply voltage: 120/240VAC, 50/60HZ or 24VDC

Power: 3W

Shell: aluminum standard, standard

Ambient temperature: -40 to +66 DEG C

Sensitivity: 0.5pf ~ 750pf

Proof: I, C or D group; II, E, F or G group.

Power failure protection: normally closed or open, the scene can be switched.

Electrical interface: 3/4 NPT "

The L2000 level switch various probe

L843 (standard probe rod)

L843TS (rod corrosion probe)

L853 (rod type fly ash probe)

L864 (bar type high temperature probe)

L843W (cable type probe)

L843TW (cable corrosion probe)

L890 (flat probe)