Home > Products > Industrial Supplies > Machinery > Pumps Vacuum Equipment

DC50C Series

Product Appearance

          T sub-series(2phase)                 S sub-series(3phase)                A sub-series(3phase)

Specifications

Features

• Small size, high efficiency, maintenance-free, low consumption, strong anti-jamming ability, stable performance
• Brushless with no pollution, adopts high-performance ceramics shaft and high-precision carbon fiber sleeve together (stainless steel shaft optional for reducing cost)long life span
• Stator and control circuits are completely sealed by epoxy resin completely separated with rotor, waterproof, avoided water-leakage problem which long exists in normal DC motor pump products
• Protection functions can be customized such as lock protection, dry-run protection and so on.
• Wide range of working voltage; parameters can be adjustable, e.g. 12VDC pump can have lift of 1m and lift of 3m with the same pump body.
• For A/S sub-series,soft-start without impact,can be directly powered by solar panel; circuit parts and motor parts completely separated, no electronic components inside pump body; pump body is made of high-temperature-resistant material, so pump can continuously work at fluid with high temperature (as high as 100C); have several protection functions, such as impeller&rotor lock protection, polarity reverse-connected protection, over-load protection, over-current protection, etc.
• For A sub-series, it's easy to regulate the power/speed of pump via PWM signal/ 0~5V analog signal/ potentiometer; flow rate & lift can be smoothly adjusted
• Reduced the mortality to 0.05% after long-time study by R&D dep.
• Lift of pumps can be doubled when they are connected in series
• Suitable for submersible installation or land use (should be located below fluid level)
• Offer ODM serve for pump and other controller system

Electrical parameters (only for reference，parameters can be customized for specific requirements)

​

Difference between 2phase & 3phase brushless DC pump

Diagram of 3phase brushless DC pump connection

                      S-Series                                    A-Series
Potentiometer Speed adjusting connection:
Contact the red and black wire to both ends of potentiometer(variable resistor),then contact the yellow wire to the middle of potentiometer,Speed canbe changed by turning the potentiometer. Potentiometer speed adjusting is the same with VR speed adjusting(Remove the potentiometer and contact the speed adjusting wire like VR speed adjusting connection bellow).
PWM(50-800HZ/Amlitude 5V) or VR(0-5V) Speed adjusting connection:
Contact the yellow wire to the control system's speed control signal output interface(PWM or VR) and contact the black wire to the ground lead in the control system.hang the red wire on the air.

Flow rate-lift Curve

Dimensions of pump

 Selection guide