Home > Products > Consumer Electronics & Lighting > Lighting > LED Lighting

※Features:

• High Lighting Efficiency: > 95%
• Low energy consumption, saves 80% power comparing conventional lights
• Replacement: 230W High Pressure Sodium Lamp
• 3 years warranty.
• Energy saving: with low power consumption 70W,150W High Pressure Sodium Lamp
• Long lifespan: 50,000hrs, which means less replacement as compared to halogen lights, helping to reduce costs, maintenance and waste disposal.
• No UV radiation, No RF interference
• CE&ROHS approved
• Less than 6% light attenuation within 5,000 hours running, 50,000 hours lifespan
•  
•  
• ※Function parameters:

※Installation Instruction (as above photo):

1. Please firstly install the reflector properly on the heat sink, and screw down.

2.Then screw down the hoop into the top cap.

3. Hang the body lamp on the installation site.

4. Please hang the chaining steel wire on another installation device.

5. Connect Live Wire/Null Wire/Ground Wire to electric cable properly and switch on

※Notice:

1. The hook of installing the LED high bay light bearing ability must be more than 30 KG weight, or could do a personal safety;

2. The wire must be passed 3C certification of two core cableto reduce the risk of fire hazard;

3.The wire is three core sheath line from the LED high bay light derivate, the brown wire is used to pick up the fire wire,
the blueline is used to pick up the zero line, yellow green line is in the ground, wired attention, do not the anti- ;

4.After wiring, the wiring head must do insulation treatment, copper wire is not exposed outside，to avoid a short circuit or get electrocuted;

5.Installation should pay attention to disconnect the input gates , to prevent electric shock;

6.Non-professionals are not allowed to open the power box, and maintenance.

※Application:

Our led high bay light are suit for Supermarket ,Shop ,work shop, Factory, exhibition center, waiting hall, stadium, channel places, etc.

※Note:

1. Before installation, cut off power to prevent electric shock, and avoid touching

The surface of light while working.

2. The light should be avoid installed in place of heat, hot steam and corrosive gas, so as not to affect their working life.

3. Before installation, make sure that installation position can withstand 10 times the weight of the product.

4. IP65 Led light but can’t be put into water, please pay attention to the waterproofing when using outside.

5. Please install on flat places with no vibration, no rocking and no fire hazard, pay attention to avoid dropping down, colliding and knocking.