Home > Products > Electronics & Electricity > Other Electrical & Electronic

Product Summary
The entire JL-240 series twist-lock receptacles were designed for the lanterns those intended to have an
ANSI C136.10-2006 receptacle to fit a twist-lock photocontrol. This series conform newly published ANSI
C136.41-2013 to allow a LED lamp multi-controlled through the receptacle, and obtained cRUus
certificates under UL file E188110.
This item JL-240TL-XA1412R7P offers 4 gold-plated low voltage pads on the top surface to fit
photocontrol has ANSI C136.41 conforming spring contacts, and offers 4 corresponding wires at rear back
for signal connection.
This item offers 360 degree rotation limiting feature to conform ANSI C136.10-2010 requirements. After
simply fit its Rear Seat onto a lamp housing with 2 screws, the assembled receptacle body can be handy
snapped on the Seat for mechanical installation completed. Rotation will be held during photocontrol
installation or removal by pressure applied vertically.
This item has multiple gaskets built-in already for IP65 protection.


Technical Data
Model No. JL-240TL-XA1412R7P
Power Volt Range 0~480VAC
Rated Frequency 50/60Hz
Power Loading 15A max. / AWG#16: 10A max.
Signal Loading 30VDC, 0.25A max.
Ambient Temperature External* -40ºC ~ +70ºC
Receptacle UV stabilized Polycarbonate (UL94 5VA)
Power Contact Solid Brass
Signal Contact Nickel plated Phosphor Bronze, Gold plated
Gasket Thermal Elastromer (UL94 V-0)
Power Lead 14AWG, AWM1015
Material
Signal Lead 18AWG, AWM1015
Leads 12"
Overall Dimensions (mm) 69Dia.x 38
* Ambient Temperature rating is for the receptacle body outside luminaire.
Installation
Disconnect power; wire the receptacle according to the diagram below. An arrow indicating
NORTH on the top of the receptacle is used to assist correct direction. Push the photocontrol on
and turn it clockwise to lock into the receptacle