Home > Products > Construction & Decoration > Curtain Wall

Application field

External aluminum honeycomb panel, decorative board, metal clean partition, ecological doors, bathroom toilet partition board, ceiling board of the adhesive, such as: color steel plate, aluminum, aluminum honeycomb panel (paper), PU, rock wool, plasterboard, baume plate, such as composite adhesive, for metal, wood, foam material has excellent adhesive performance.

Technical parameters (the following parameters of 25 degrees Celsius temperature test)

The main agent curing agent (B) (A)

Status: viscous fluid flow

Density: 1.60 + / - 0.05 g/cm3 0.05 + / - 0.05 g/cm3

Color: grey light yellow

Viscosity: 5000 + 1500 mpa? S 100 + 100 mpa? s.

Mixing ratio (weight ratio) : 5 to 1

Mixture density: 1.51 + / - 0.05 g/cm3

Sizing time: 90-120 minutes (after mixing) can be adjusted according to the production requirements

After mixing state: fluid

Glue dosage: 150-400 g/cm2

The initial moisture time: 5-8 hours

Fully viscous force time: 5 days

No exothermic peak: 10 days

Tg: 33-35 degrees Celsius

Steel shear strength of steel, more than 10 mpa

Environmental performance: in accordance with GB18583

Apply after curing temperature: - 40-100 degrees Celsius

Matters needing attention

1. The moisture will be negative influence on the main agent and curing agent, must prevent be affected with damp be affected with damp in use, after use must cover tightly barrel cover, in a dry place;

2. Construction must be according to the weight than A: B = 5-1 used after even mixing, can also be used in A two-component glue machines (with the salesman to learn more about specific information)

3. The curing agent (B) under 13 degrees Celsius with crystallization phenomenon, must be heat treated (heating temperature in 40-50 degrees Celsius);

4. Tolepoxy J301 can be used at low temperature, 10 degrees Celsius under low temperature curing speed is slow, such as to speed up the curing can add promoter Tolepoxy T311); Also can be used at high temperature, 65 degrees Celsius cure time 35 minutes, 90-100 degrees c cure time is 7-10 minutes;

5. The adhesive substrate must be oil removal, dry, dust-free, clean processing, it is recommended to use must be cleaned up when the bonding strength increased significantly;

6. Must store in dry indoor environment, recommended temperature (16-35 degrees Celsius), avoid direct sunlight, high temperature storage, below 15 degrees Celsius, damp environment;

7. Shelf life: intact packaging for 12 months

8. Packing: the main agent (A) 25 kg plastic drum, curing agent (B) 20 kg drum, can also according to customer's requirement in cans.