Home > Products > Consumer Electronics & Lighting > Lighting > Torch & Flashlight

SPECIFICATIONS:

◆Model: WM16 Underwater Photographing Light

◆Bulb: BridgeluxCOB LED

◆Color temperature: 5000-5500 K

◆Output levels: high> low

◆Runtime:high90 min, low 150 min

◆Reflector: no hotspot design, no reflector

◆5 mm polycarbonate lens

◆Body material: durable aircraft-grade aluminum

◆Angle of light beam: 110°

◆Surface treatment: premiumtype III hard-anodizing

◆Color: Black

◆Battery: 18650 Li- ion Battery *3 (in a battery pack)

◆With battery over-discharging protection, and polarity reversing protection

◆Operation voltage: 12.6 V to 8.4 V

◆Waterproof: 100 Meters underwater

◆Dimensions: 152mm (length) * 67 mm (dia. of lamp head) * 55.4 mm ( dia. of lamp body)

◆Weight in air: approx. 542 g. (without battery); approx. 810 g. (with battery)

◆Underwater weight: approx. 380 g. (with battery)

POWER INDICATOR:

Ring-shaped power indicator surrounding the switch lights up in green, or yellow, or red, when power capacity is above 70%, or between 70-40%, or between 40-10%. It flashes in red forpower capacity between 10-5%, and turns off when power capacity is below 5%.

LOW BATTERY WARNING:

The light flashes 3 times if the powercapacity is less than 10%; it repeats after 5 seconds, and then switches to lower brightness; it switches off when thepower capacity is less than 5%.

BATTERY INSTALLATION:

1. Unscrew thelamp head, holding it pointing upward.

2. Remove used battery pack and replace with fresh one disregarding the positive or negative

electrode..

3.Screw the lamp head down. Do not overtighten to break the O-ring.

BATTERY CHARGING:

1. Plug the charger in the power socket, andits indicator light is green in the free-load status.
2. Plug the other side of charger in the port of the battery pack.The indicator light of charger lights in red if the batteriesare not fully charged; it lights in green after the batteriesare fully charged.
3. When the battery pack is fully charged, unplug the charger.

MODES CHANGING:

1. Press button switch and hold it for three seconds to turn on or off the light.

2. When the light is on, successively quickly press the switchto cycle through high, and low.

3. After each pressing, the switch will bounce back to original position automatically.

CAUTION:

1. Never attempt to repair or modify the light by yourself.
2. Please check the light regularly for sharp edges, scratches or damages to the surface or O-ring, as this can cause the light to flood under pressure. PLEASE LUBRICATE THE THREADS, O-RING GROOVE WITH SILICONE GREASE TIMELY.
3. Please rinse the product surface thoroughly after each use, and allow sufficient time for light’s being dry both inside and outside before storage.
4. Please remove the battery pack for transport or storage. Do not lay the battery pack in a fire or expose it to direct heat. Do not wet or hit the battery pack. Please charge the battery pack after each use, or once every three months, to avoid over-discharging.
5. Never leave the light unattended when it is on.
6. Please keep the device out of the reach of children or pets.
7. Never shine the light to human or pet’s eye.
8. To prevent lens burning caused by over-heating, please do not cover or block the lamp head when the light is switched on in the air.

WARRANTY RETURN POLICY:

Please contact your local distributor or retailer for information on how to handle your warranty items.