Home > Products > Home Supplies > Clocks Watches

FEATURES:

• Large1.8” LED Display
• HI or LOW Alarm Volume
• HI or LO Display Brightness
• 9 Minute Snooze
• 9V Battery Back up (Battery Not Included)
• Large Nightlight

POWER SUPPLY

1. Begin by pl ing in the power cord into a standard household outlet. The display will flash indicating it needs to set.

SETTING THE TIME

1. Press and hold the TIME SET button down to activate time setting.
2. While holding down the TIME SET button, press the HOUR button to advance to the correct hour. The PM indicator will light when the hour is advanced into the PM time.
3. While holding down the TIME SET button, press the MINUTE button to advance to the correct minute.
4. Release the TIME SET button when the correct time is shown on the display.

SETTING THE ALARM

1. Press and hold the ALARM SET button down to activate time setting.
2. While holding down the ALARM SET button, press the HOUR button to advance to the correct hour. The PM indicator will light when the hour is advanced into the PM time.
3. While holding down the ALARM SET button, press the MINUTE button to advance to the correct minute.
4. Release the ALARM SET button when the correct alarm time is shown on the display.

USING THE ALARM

1. Slide the ALARM ON/OFF switch to the ON position, On the front of the clock the Alarm Indicator dot will be lit.
2. Slide the ALARM ON/OFF switch to the OFF position to deactivate the alarm. The Alarm Indicator dot will no longer be visible.

USING THE SNOOZE

1. Pressing the SNOOZE/LIGHT button when the wake-up alarm is sounding will cause the alarm to stop and the alarm will sound again in nine minutes. This will happen each time when the SNOOZE/LIGHT button is pressed.

USING THE DIMMER

1. Slide the DISPLAY DIMMER HI/LOW Switch to select the brightness of the LED display

USING THE ALARM VOLUME

1. Slide the ALARM VOLUME HI/LOW Switch to select the Hight or Low alarm volume level

USING THE NIGHT LIGHT

1. While the alarm is not sounding, press the SNOOZE/LIGHT button to control the night light

       NOTE: The default is OFF setting.

BATTERYBACK UP

1. Turn the clock over and insert a 9V battery as indicated to provide battery back up. The battery will hold the ALARM and TIME settings until power is restored. There will be not display under battery power and the ALARM will sound at the correct time. If there is no battery and the power is interrupted, the display will flash 12:00 and the ALARM and the TIME will need to reset.

CARE OF YOUR CLOCK

1. Replace the back up battery annually, or store the clock without a battery when not in use. A soft cloth or a paper towel may be used to clean your clock. Do not use any corrosive cleaner or chemical solutions on the clock. Keep the clock clean and dry to avoid any problems.