Home > Products > Chemicals > Organic Chemical Materials > Other Organic Chemical Materials

 1.Description of  Platinum Silicone Rubber Compound for Christmas candle molding

Prototype design silicone rubber G840 is a kind of two-component addition silicone rubber, consisted of lowable liquid part A and B. which can be cured at room temperature or heated temperature.Prototype Design RTV Silicone G840 has many advantages as below:  Good liquidity, easy to operate, high transparency, without being limited by the thickness of the products, excellent temperature resistance and thermal stability and so on.It’s suitable for both pouring method and brushing method.

2.Characteristics of Platinum Silicone Rubber Compound for Christmas candle molding

1. without being limited by the thickness of the products, depth of curing.

2. Has excellent temperature resistance from 300-500 ℃

3. Good tensile strength and tear strength, with a variety of duplication times

4. Has excellent electric properties and chemical stability, resistance to water, ozone abd weathering

5.  Low shrinkage (≤0.1%), the crosslinking process don’t release any low molecular weight, so the volume will not changed.

6. Good liquidity, easy for pouring; it can be cure at both room temperature or heated temperature , easy- operation.

3. Using instruction of Platinum Silicone Rubber Compound for Christmas candle molding

1. Mold’s surface cleaning: We can brush or spray the release agent to the surface of the mold, and the release agent or the potting material can be the liquid wax.

2. Mixed: mix the part A and part B( on a weight ratio of 10: 1) by manually or equipment.

3. Pouring the silicone rubber into the frame to cover the model completely with 3cm thickness.

4.Remove air bubbles: We shall Remove air bubbles before pouring the liquid silicone rubber.When a small amount of silicone rubber be use, it can be operated in the vacuum dryer, under vacuum, the volume of rubber foam can increase 4 ~ 5 times, therefore, the volume of the vacuum dryer machine shall be 4 ~ 5 times larger than the volume of rubber, then the volume of silicone material will back to a normal volume in a few minutes, until the surface without air bubbles,(approximately 10 minutes) ,this air bubbles-removed process is completed.

5. Vulcanization and Demould: after mixing and vacuum pumping,the prototype design silicone rubber mold can cured within 30 minutes under 120 ± 5 ℃ baking temperature , or 2 to 3 hours curing under 60 ~ 70 ℃ baking temperature, or 24 hours under room temperature. The curing temperature and curing time can be changed according to the process conditions.