Home > Products > Chemicals > Adhesives & Sealants

PU8730 Windshield replacement adheisve sealant

PU8730 One component selante adesivo de carro New design

PU8730 is one component direct glazing polyurethane adhesive, can be used for the high strength adhesion of the glass and the body of the automobile.

Key Features

1. Single component, moisture curing, no dripping for vertical application
2. Good elasticity and initial adhesion, high bonding strength
3. Can withstand high strength dynamic loads; no sagging while interrupting gluing
4. Good Adhesion with various substrates such as glass, aluminum plate etc.
5. Paintable and polishable surface, outstanding application property
6. No corrosion on base material, no penetration pollution, little volatile smell
7. Good aging resistance and weather resistance.

Technical Data Table

Directions for Use

Tool: Manual or pneumatic plunger caulking gun

Clean before operation

Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants and any protective coating. Dust and loose particles should be cleaned.

For cartridge

1.Cut nozzle to give the required angle and bead size

2.Pierce the membrane at the top of the cartridge and screw on the nozzle

3.Place the cartridge in an applicator gun and squeeze the trigger with equal strength

For sausage

1.Clip the end of the sausage and place in barrel gun

2.Screw end cap and nozzle on to barrel gun

3.Using the trigger extrude the sealant with equal strength 

Attention of operation

Wear suitable protective clothing, gloves and eye/face Protection. After contact with skin, wash immediately with plenty of water and soap. In case of accident or if you feel unwell, seek medical advice immediately.