Main USES:
Hydraulic double location pyrograph machine can be sublimated, solvent ink color logo and the heat transfer in such as cotton, hemp, chemical fiber, nylon fabric and ceramic products, also can be flocking pyrograph and foaming printing process such as heat treatment, and the low temperature low pressure line of the clothing and fabric of the adhesive, such as clothing, shoes and hats and other glue, also can be used in the production of small batch handkerchief
Product features:
Electronic digital display temperature control temperature, high accuracy, (plus or minus 2 ℃).
The heating principle of the imported aluminum alloy is adopted, the energy saving, the temperature is even, the temperature difference coefficient is small.
Electronic digital time control, high accuracy, beautiful;
Random pressure regulation
steps
1. Connect the compressor connector, open the air pressure, adjust the pressure regulator 6 to (4pb-6pb), and make the heating plate rise;
2. Connect the compressor connection, open air pressure, and make pressure gauge modulation (4pb-6pb) to make the heating plate rise;
3. Turn on the power supply, turn on the power switch, and then the indicator light is on.
4. Adjust the required time and temperature. (see the last page for details.)
5. After adjusting the temperature and time, wait for the machine to heat up.
6. When the temperature is over, the thermometer will light.
Flat on silica gel mat 7, clothes, put on pyrograph paper, (note that the face of positive and negative of pyrograph paper promote mesa to hot press location, press the start switch, pressing, the items into the pyrograph paper, put on high temperature cloth again, press the start switch, hot stamping, time the meter.
8. After completion, the heating plate will automatically rise and pull out the countertop.
9. Hot items. If it is cold, please wait for 5-10 seconds to tear off the scald paper. If it is hot, please tear off the hot stamping paper immediately.
10. After the successful test, push button 1 to the semi-automatic file. After placing the hot stamping material, as long as the mobile handle 7 to the hot stamping material is directly above, hot stamping will start automatically. In case of emergency, you can press the button 6 to stop, and after the emergency stop button is reset, you can continue the hot stamping.
Maintenance:
1, pressure: not even, with feet first hot plate edges measurement distance from bottom edges are consistent, such as inconsistent, adjustable heating plate center four services screw nut "under", cut close to the heating plate increases, to the "on" tighten lower heating plate. Pressure is too big or too small (usually pressure is 4 kg - 6 kg), adjust the filter on the regulator on the "+" direction, increase the pressure, "-" to reduce pressure, or check air compressor pressure is normal (usually air compressor pressure is 6 kg - 8 kg).
2. Time: when the bottom plate is in place, the time is not displayed, and the proximity switch is checked. If the distance is moderate, it should be adjusted to less than 4mm, and the time is up, the heating plate will not come down, and the circuit will be checked.
3. Temperature: adjust to set temperature, do not heat up, do not control temperature, check the temperature control table, contactor, whether the heating plate line is in good contact with the original fault of the electrical equipment.
Note:
The machine must have a proper and secure grounding line.
Successful stamping needs to have the correct time, temperature and pressure, thickness and material of clothes and pyrograph paper of all kinds of all affect the effect of hot stamping, try various pyrograph paper must be very hot after samples, before mass production.
Hot stamping needs temperature and.
