Home > Products > Electronics & Electricity > Electric Control System

Motor   fan  changed to remote control and changed  to PWM energy saving dual output interlock. 
Intermittent switch, on /off cycle loop timer
Application scenario fan ventilation, fresh air system, production line cooling line heating line, spraying, LED lighting control flashlight control etc

NKAC150Y(remote control)1 input 2 output PWM on/off interlocking controller

1 operational principle   The on/off time of the output is controlled  by the controller, so the output voltage and frequency are the same as  the input terminal. PWM=Pulse Width Modulation Power

2 operational process Input AC230V 50/60HZ(built-in 250V 2A Fuse)，input=Yellow output（no PWM no interlocking）

Press yellow label  speed key of the of the remote-controller, the Yellow socket = Yellow knob PWM output, Press red label swing key of the remote controller, the red socket =red knob PWM output.

press remote-controller yellow/red label button when PWM output, Controller interlock default：

Yellow LED brightness = yellow socket on and at the same time red LED extinguishing = red socket off, 

yellow LED extinguishing = yellow socket off and at the same time red LED brightness = red socket on

3 Input AC220V,press the yellow/red label button of the remote-controller ，the yellow/red knob PWM settings will be effective, and the yellow/red socket will have the PWM output.

Rated input AC230V (built in 250V2A Fuse)

Yellow socket output AC230V 600mA ,Red socket output AC230V 600mA.

After  input  AC230V, the yellow-red  socket is still Electrification when they are off,

at this time one pole is continuously  on, and the other is off by the high resistance .

Don't touch the metal part of the input & output socket.

The remote-controller must aim at the remote- receiver , and the remote-controller distance is 5 meters.

Yellow output of PWM can only be obtained until by pressing the yellow label button of the remote-controller, and  Red output of PWM can only be obtained until by pressing the red label button of the remote-controller.

We can customize DC input & output DC PWM, or max-power PWM, outlet length, international voltage pin or socket

NKAC150Y (remote control) standard configuration  2 flat pin input AC230V 50/60HZ (250V 2A Fuse) 

Output 2 flat sockets ,yellow socket output AC230V 50/60HZ 800 mA ,

red socket output AC230V 50/60HZ 800 mA (including  output socket line length 75 mm)

Controller size (not include input pin)length 98x wide 54x high 35mm, 

pin length 35x wide 20x high 25mm controller  weight (includes pin socket)300g

Hand held remote-controller input DC DC3V =AAA-1.5V  battery X 2.

Handheld remote controller weight (includes battery) 200g 

size length 105x width 40x high 15mm

Content Disclaimer   All information in this document may be changed without notice. All information in this document should not be regarded as a commitment of NKAUTOMATIC. NKAUTOMATIC. is not responsible for any mistakes that may occur in this article.

Copyright@ NKAUTOMATIC.COM. all rights reserved.