Test apparatus for the Bending Strength
Product Description
APPLICATIONS& TEST PURPOSE:
The machine is used to test bending strength of handle, under specify load on handle slowly, check the fastness of connection between two parts.
DESIGN STANDARD: BS EN 12983-1
STANDARD PARAMETERS:
1. Servo motor actuator generate a maximum vertical force of 250N
2. A 300N force sensor was used to measure and control the force apply.
3. Load apply gradually without shock , to the handle until the load is supported or record the peak force when the fixing system fails.
4. Torque rod diameter: 10±1mm
5. Fixture: tensile and bend fixture each one
6. Out dimension: (L×W×H) 750mm×452mm×875mm
7. Power: 1 phase, AC 220V, 50~60Hz.
APPLICATIONS& TEST PURPOSE:
The machine is used to test bending strength of handle, under specify load on handle slowly, check the fastness of connection between two parts.
DESIGN STANDARD: BS EN 12983-1
STANDARD PARAMETERS:
1. Servo motor actuator generate a maximum vertical force of 250N
2. A 300N force sensor was used to measure and control the force apply.
3. Load apply gradually without shock , to the handle until the load is supported or record the peak force when the fixing system fails.
4. Torque rod diameter: 10±1mm
5. Fixture: tensile and bend fixture each one
6. Out dimension: (L×W×H) 750mm×452mm×875mm
7. Power: 1 phase, AC 220V, 50~60Hz.
Product Image
Send Inquiry to this Member
Related Products of this Company
This member assumes full responsibility for the content of this listing. DIYTrade accepts no responsibility whatsoever in respect of such content.
To report fraudulent or illegal content, please
click here.
China Suppliers Quick Searching:
,
