Home > Products > Industrial Supplies > Machinery > Welding Machinery

Application：

It is Automatic shear welder and can be used for steel welding pipe production, continuous stamping production and other production. It can be finished the welding work of strip material(including stainless steel, carbon steel ,galvanized strip, copper, aluminum) .

ADVANTAGE:
1. Adopt advanced shear process without burr.
2. It is easy to work for hydraulic pressure as power.
3. Clamping plank and keeping the level,all these controlled by foot switch
4. Use tungsten TIG welding;The welding seam is small without polishing. And it is high strength.
5. Automatic for welding.

FEATURES:
1. Adopt oblique shear;Two down knives should be fixed on the down knife base.The base connected the frame by screws.The up knife should be installed on the moved frame.There is oil tank to move for up knife support frame.
2. Tighten;The position should be on the frame.Make two strips to keep the level and press;Tighten the position to make right and left parts;It can be controlled the air cylinder by foot switch.
3. To butt joint of right and left two pieces of strip, clamping the middle of copper electrode plates by clamping device ;The welding torch should be fixed on the moved slider,It can be drive by screw shaft.
4. The screw shaft drive by motor; The motor can be adjusted speed by the inverter output frequency, then adjust the speed of welding torch.
5. The right and left indication light on means pressing tightly. On the contrary, it means sending the materials.
6. It can be controlled by foot switch for right and left tight;The device will be move for foot action.
7. The shear foot switch is in the middle;The up knife will cut down for pressing the switch;Then the up knife will be back for loosening the switch.
8. Adjust method:arc strike at edge 1-2.5mm;arc failure at edge 0.5-4mm.
9. Motorized button: There are two buttons of welding torch-forwarder and backward and the position of the welding torch can be manually adjusted.