Home > Products > Industrial Supplies > Other Industrial Supplies

Stainless steel 304, 316L material, sanitary pump, specialized in food industry, pharmaceutical industry involving beer, beverage, mineral water, bioengineering, pharmaceutical and other fields. We supply self-priming pump, sanitary pump, return pump and other series of stainless steel pumps and accessories.

1、 Stainless steel sanitary pump, sanitary centrifugal pump product overview:

Sanitary centrifugal pump is a single suction, single-stage, centrifugal sanitary pump, which is suitable for conveying milk, beverage, wine and other liquids. It is an indispensable conveying equipment in food, chemical, pharmaceutical and other industries. The working temperature is about 80 ℃. Among them, high lift pump is suitable for pipe sterilization, yogurt temperature equipment, CIP cleaning and other systems with high resistance.

2、 Stainless steel sanitary pump, sanitary centrifugal pump mechanism features:

The sanitary pump is composed of pump body, pump seat and motor. Each part is connected by bolts.

The support feet under the bottom plate can be adjusted freely, which is convenient for installation without fixed installation foundation. The outlet pipe can be installed in vertical or horizontal direction according to different needs.

This series of pumps are designed with smooth, rigid structure and thick wall. In the selection of materials, pump body, pump cover, impeller and other parts in contact with materials are all made of AISI316 or AISI304 stainless steel.

Mechanical shaft seal is made of high quality stainless steel and silicon carbide. Greatly improved the wear resistance and moisture type, extended the applicable life.

The motor adopts the international famous "ABB" motor with the protection grade of IP55. F insulation and wide voltage structure.

The pump body and impeller are made of integral precision casting, and all parts are surface treated. During the installation, the special fixture shall ensure the dimensional clearance.

The shaft seal adopts an open structure, so even if there is a small amount of leakage at the shaft seal, it can be observed in time. The motor will not overflow even if it is not detected for a short time. Thus, the service life of the motor is guaranteed.

The sanitary pump has the advantages of simple structure, convenient disassembly, low voice, high efficiency, gentle and gentle material treatment, meeting the requirements of food hygiene and ensuring the original flavor of the product.

3、 Instructions for stainless steel sanitary pump and sanitary centrifugal pump:

During centrifugal sanitary installation, the position of the pump should be lower than the suction liquid level (if the installation position of the pump is higher than the suction liquid level, the pump should be filled before pumping). Before use, check whether the rotation direction of impeller is correct; whether the nut of pump inlet and outlet pipe joint is tightened; the sealing ring between pump cover and pump body is well padded. Before use, the parts contacting with materials shall be steam sterilized to ensure food hygiene.

A butterfly valve shall be installed at the outlet of the pump to control the flow. Do not operate under overload for a long time to avoid damaging the motor.

CIP cleaning shall be carried out immediately after the use of water pump to prevent material adhesion. If there is no CIP, it needs to be cleaned manually. During cleaning, hot water can be used to pass first, then disassemble, brush all parts of the pump in contact with the material with a brush, wash with clean water, and then install them in order after cleaning.

If any material drops on the ground after the pump casing is found in use, it indicates that there is leakage at the shaft seal. At this time, the mechanical seal device on the shaft can be checked. If it is severely worn or the seal is damaged, it can only be used after replacement or grinding.