HONGDU TESTING EQUIPMENT CO.,LTD.
HD-10D Power Plug Integrated Tester
Product explanation:
This tester is an integrated tester for plug.It is used to test the continuity,polarity,insulation,high-volt,leakage current,E-wire high-voltage of power plug.It meets the requirements of many international standards such as BIS, UL, CSA, VDE, BSI, DIN, CCC, IEC,etc.It is a totally automatic testing machine make your operation more convenient and simple.
Features:
* All of the test subjects will done automatically.
* The inner/outer high-volt output value can be adjusted separately.
* Test speed is quickly,all test subjects will be achieved in 2 seconds.
* The PLC control system comes from Mitsubishi,Made In Japan.
* The relay comes from Schneider,Made In French.
* If the specimen is incompetent,there is a alarm by buzzer and light.
* If the specimen is incompetent,this machine will stop at once and show you which subject is incompetent.Until you push the emergency button it will restart a new test.And a switch with key can be made to order to replace the high-volt starting button,it is very useful,because when a alarm happen,the operaters can not restart this machine,only when the managers have checked over and restart it by key the machine will be working again.
* When test over,the sample will be pushed out automatically,and a “T” or other characters will be marked on it(English characters only).
* A big current with 0~30A will be applied on E wire to check whether it is eligible.
Technical parameter:
|
Polarity test
|
Test E,L,N wires in sequence
|
|
Insulation test high-volt
|
DC 500V +-3%
|
|
Insulation resistance
|
5,100MΩ(can be made to order)
|
|
Inner high-volt
|
0~5KV +-3% (adjustable)
|
|
Inner leakage current
|
2,5,10mA(can be made to order)
|
|
Outer high-volt
|
0~5KV +-3% (adjustable)
|
|
Outer leakage current
|
2,5,10mA(can be made to order)
|
|
Rated power
|
500VA
|
|
E wire test current
|
0~30A(adjustable)
|
|
Length of sample
|
less than 10m which 1.5mm2 square
|
|
Cylinder power
|
compressed air with 0.4 to 0.6Mpa
|
|
Dimensions
|
1200mm W,900mm D,1540mm H
|
|
Power source
|
AC 220V +-10%,50Hz
|
|
Weight
|
45 kg, approximate
|
NOTICE:
1,Inner high-volt is applied between L,N,E wires,and the outer high-volt is applied between L,N,E wires and jacket.
2,Both 3-wire and 2-wire power plug can be tested by this machine.
Test Objects: Power Plugs
