APD is a direct, in-line and bulkhead sensor connector that is resistant to engine, transmission and brake fluid. It also boasts very low contact resistance, so you can benefit from maximum signal intergrity. APD is available in 1-, 2-, 3-, 4-, 6- and 7 position versions and has been designed to meet all DIN 72585 requirements.

• Sensors
• Traction/Anti Skid Control
• Brake Control (ABS)
• Magnetic Switch Control Systems
• Valve Control (Water, Oil, Air, Pressure)
• Lightening Systems on Trucks and Trailers

  Performance Specifications
  Contact Resistance	equal or < 5m ohm
  Insulation Resistance	equal or < 10m ohm
  Current Rating	21 A max. for wire size 1,5 mm2 / 25 degrees C
  	29 A max. for wire size 2,5 mm2 / 25 degrees C
  	34 A max. for wire size 4,0 mm2 / 25 degrees C
  Voltage	48 VDC max.
  Test Voltage	1000 VAC (Ueff)
  Operating Temperature	-40 degrees C / 125 degrees C
  	Class K2: -40 degrees C / 140 degrees C contact temperature
  Sealing acc. to IEC 529 and DIN 40050 Part 9	IP67 and IP69K
  Shock / Vibration	30g acc. to DIN 72585
  Durability	50 mating cycles
  Materials and Finishes
  Connector Housing	PBT
  O-ringl	HNBR
  Contacts	Copper alloy, tinned
  Coupling Nut	PA
  Standards and Specifications (in accordance with DIN 72585) Environmental
  DIN 40050, Part 9	Sealing
  DIN 50016	Humidity
  DIN 50021	Resistance against fluids, salt spray test
  DIN 51512	Lubricants such as engine oil, grease, etc.
  DIN EN 590	Diesel fuel, gasoline
  DIN ISO 4925	Brake fluids, anti-freeze, coolants

• R ed plastic housings
• Three point bayonet coupling
• Color coded mated pairs
• Resistant to salt spray, oils, grease, and fluids
• Quick mating with a third turn, audible & tactile feedback