用途：
　　修補干板牆、石膏板接縫、各種牆體的裂縫及其它牆面破損。
Application:
　　Virtually any commercial or residential application of drywall finishing repairing the cracks and joints or holes of drywall，plasterboard，stucco and the other surface．
主要性能：
　　優良的耐碱性，經久耐用：高抗拉強度和抗變形性，防裂紋：不變質，不起泡沫：優秀的自粘性，不需要預先上底塗，使用快捷，施工簡便。
Performance include:
　　Self—adhesive，faster application，no pre-plastering required，easy to apply，resists cracking，do no rot，no blisters or bubbles，more environmentally—friendly job。It won’t tear，shrink，stretch or bubble，while it hides joints，cracks and holes permanently.
規格：
　　8×8．9×9目／英吋：55—85克／平方米。
通常為白色。
　　寬度：25—1 000毫米：長度：10—153米。
特殊規格及尺寸可按客戶要求定做。
Specification:
Width(mm)：25，35，48，50，100，150，200,1000．
Length(m)：10，20，30，45，90，153
Mass：55—85g／sq．meter．
Mesh：8*8 or 9*9 mesh／Inch
Colour：white，yellow，blue etc．．
Drywall seaming tapes as well as private label and
unlabeled tapes．
Each roll is shrink-wrapped，or plastic hand bag．
0ther specification are available upon request．
Testing standard：ASTM-D579
施工方法：
1．牆面保持清潔和乾燥。
2．在裂縫處貼上膠帶並壓緊。
3．確認縫隙已被膠帶蓋住，然後用刀把多佘的膠帶切斷，最後刷上灰漿。
4．讓其自然風乾，然後輕輕打磨。
5．填充足夠的塗料，使其表面光滑。
6．切除漏出的膠帶。然後，注意所有的裂縫都已得到適當的修補，用細微的復合材料將補縫週圍修飾，使其光潔如新。
How to use:
1．Wall must be clean and dry；
2．center and apply tape over the length of the joint and pressing firmly；
3．apply a generous first coat of compound over the tape andthrough the mesh，making sure to completely fill the joint crevice．When the joint has been completely filled，wipe off any excesscompound with the drywall knife leaving enough to cover the tape．
4．Let dry completely，then sand slightly．
5．apply sufficient thin finishing coats to produce a smooth wall surface．
6．cut of butted boards do not have a tapered edge．Therefore，special care must be taken to assure proper compound penetration of all joints．This may result in slight build—up of compound that will require an increased amount of edge feathering．



注意：
1.沒有完全的修補將會有裂縫的產生
2.為了效果好，請選用凝態復合物
Caution:
1.Failure to completely fill the joint may result in cracking.
2.For best results, use a setting-type compound.