No-switch temperature auto-controll double seats heating product

1 Composition:consist of four heating pads and a line
2 Assemble
  (1)Take off the cover of the seat,put the pads on,the four-core plug must connect with the driver's seat.
  (2)Put the line under the seat through the gap between the back and the seat.
  (3)Connect the pads first,then connect them to the main line.
  (4)There are three lines in the main line,black red and yellow.Connect the red line to the place where the current is more than 10A,connect the black line to the ground line(such as the nut under the driver's seat),Connect the yellow line to ON line.
  (5)put the main line under the feet,put the cover back to the place.
3 How to test it
  (1)Start the car
  (2)If it is winter,when the temperature is under 13 degree the seats will start heating until the temperature is fit the body needs.
  (3)If it is in summer,when the car is not working disconnect the mian line and the then start the car and connect the plug and the main line,then the pads are heating,and stop the car,then start the car again,the pads should not heating,means the product it assemble correctly.
4  How to use
  (1)In winter when the car started,the pads will start heating itself.
  (2)The pads will at the temperature that fits the body.
  (3)When the car stops it will stop heating.
5  Wariness
  (1)The three lines should connect correctly and tight.
  (2)Use the Double-sided adhesive to make the pads tight on the seat.
  (3)Put the controll box under the seat.
  (4)If the product is out of the controll,disconnect the plug and the line.

                    The system five switches seat heater(double/single seat)
1 Assemble
  (1)Put the pads on the back and the bottom of the seat.Connnect them and connect the line of the pads to the main line.
  (2)Put the controller near the reserve hole.Make it bigger if the hole if not big enough.The size of the hole should fit the controller.Then link it to the main line
  (3)There are two lines in the main line,connect the red line to the place where the current is more than 10A,connect the black line to the ground line and be sure they are stabilizing.
2  How to use
  (1)There are two symbols on the controller,"L" means left seat,"R" means right seat.
  (2)Level 1 means lowest temperature,5 mwans highest temperature.
  (3)When you want to stop heating just put the controller at level "0".
3  Points for attention
  (1)Do not put line out of the seat.
  (2)Make sure the red line and the black line connected correct.
  (3)After all this product is easy to use.