The machine is operated by motor(2) via belt (10) driving draft (11) to make liner (5) rotate at a high speed. Slurries are delivered to liner (5) through feed pipe(4)and are subject to stronger process of separation under the action of centrifugal force.Heavy minerial remains in the lattice chute of liner(5) and light mineral is drained via tailing chute(7).Concentrate is discharged through outlet (10) after one shift operation and shutdown of the machine.

 

Before starting the preparation and check:

1. According to the instructions of motor required for the preparation and check before use.

2. Check the equipment whether the anchor is stable.

3. Check the state of V-belt tension and adjust appropriately (factory test machine has made adjustments)

4. Check the equipment without interference of moving parts, manual turning checks.

5. Check the discharge port (10) is closed.

After the above five ready to check , turn the power to start the motor, check motor rotation direction and equipment requirements are the same, whether the interference of moving parts, and then turn on the power, make the equipment into normal operation.

 

When the equipment into the normal operation, the recoil valve open ,at the same time, feed the required liquid-solid ratio slurry.

 

1 monitor the stability and current by use of conventional motor.

2 watch every moving parts without exception condition,.

3 pay attention to slurry ratio, try to adjust it in time.

4 intervals for a period of time, open the peephole on the cover, observation of inner sleeve (5) resand between cell deposition tank, with or without exception.

 

The equipment need clean up concentrates per normal work shift. Before stop, first stop feed mine, then stop the equipment, wait for equipment is stationary, unscrew the drain plug concentrate outlet , the ore concentrate into the ore tank (prepared in advance) can be. Cleaning concentrate time to 15 to 20 minutes. Then, tighten drain plug, the next cycle of operation.

 

If meet special condition, need to temporary shutdown, must first stop to feed mine, then stop backwash water, and then go down. But the downtime should not be too long, too long to prevent reslot within the set of grid sand compaction. (if required downtime long, you need to clearn concentrate first, then shutdown.) In addition, when you open again after temporary shutdown, need feed slurry first, and then give backwash water, to avoid the loss of gold particles.

 

1.       periodic maintenance according to the motor use requirement.

2.       the equipment need cleaning per shift.

3.       equipment must be shutdown if you need to adjust the drive belt or tighten loose bolts.