1. The target disks (sensors) are not composed of the electronic components used in traditional wheel aligners. The problems caused by the influence of the electronic components are eliminated.

 

1. Utlizing Patented 3Dmax Dynamic Display System It can make the observation of the real 3D profile of each wheel at any time vivdly and conveniently.
2. No Electronic Components There is no electronic components, thus none of electronic circuits trouble will occur. And the solid-state target disks made by special materials are sturdy and durable.
3. Four-point Wheel Clamps It is suitable for any kind of wheels with diameters ranging 11" to 22" standard. The holding tire clamp is optional. If necessary, the wheel clamps with maximum 27 " are available.
4. 3D Animation Technics With the specific high-speed imaging cameras and the high-performance computer, it only takes only one minute to complete the basic position measurement.
5. Unique Reminding Window Helping users complete the measurement, it offers feedback of information during measuring and monitors the measurement process effectively.
6. Pre-tightening Rotatable Jaw Fitting for most of the external steel rim and coordinating with the anti-loose retractor, it effectively prevent clamps from falling in the process of positioning.
7. Pushing the Vehicle Once The deviation caused by steel rim deformation, mechanical components deformation, installation errors and other factors can be compensated comprehensively.
8. Body Height Measurement System Utilizing the target disks for height measrsuring (optional), the height of the vehicle body’s relative plane can be quickly measured to provide reference data for car body deformation.
9. 3D Animation Adjustment Guidance Various adjustment methods of chassis position parameter are available.
10. Animation Operation Reminding All the operation systems are instructed by 3D animation which prompts the users to prepare for the next step.
11. Original Standard Reference Database This database contains the original datum and information of over 20 thousand car models.
12. PC Camera Showing Vehicle On Platform Function Equiped with high definition USB camera, which can provide real-time shooting while the vehicles driving towards the platform of the lift. No staff conducting is needed outside the vehicles.
13.Intelligent Voice Reminding Voice announcement by woman in standard British accent is set to avoid improper operation by users.
14. The Mesurement of Caster and Kingpin Inclination Caster, kingpin inclination and included angle take simultaneous measurements to test the various states of steering and suspension systems.
15. The Measurement of Vehicle Body Dimension 3D alignment can provide factual data for the repairment of car frame deformation by effectively measuring the dimension parameters, such as wheelbase, tread and axle offset, etc.
16. The Measurement of Toe-out-on Turn The measurement of toe-out-on turn can provide basic data for the adjustment of steering machanism and the changing of the bad accessories.
17. The Measurement of Tire Diameter The measurement of tire diameter can provide more specific data about the barometric pressure and wear pattern of the wheels.
18. The Measurement of Maximum Turning Angle The measurement of maximum turning angle offers great help to avoid many problems, such as vehicle driving wandering, cornering squeal and jitter of the steering wheel.

The corresponding datum plane and driving central line for calculating are constructed by the centre of four wheels got by the four target disks. Then according to the position of each disk in the plane and central line, the parameters of wheel alignment can be figured out.Therefore, measurement deviation due to the non-horizontal vehicle plane and lifting platform during the measurement can be avoided.

During operating, users can adjust the height of vehicles according to their requirements. And the IAA1 system can automatically calculate and adjust the cameras to the corresponding height. No manual work will intervene in this process. There is no influence on measurement results.

BBC: After initial installation, only one simple calibration is needed, the best measuring results can be achieved. And there is no need for repetitive calibration.