MONEL

Monle is widely used in the chemical, pharmaceutical, maritime, oil, textile and paper industries.

It is highly resistant to  (caustic) alcaline solutions, sea water and diluted sulphuric acid.

Monel-K (500) is often used when higher hardness and resistance are needed.

HASTELLOY

This material is universally used in valves and pumps where the greatest resistance is required to corrosion caused by strongly oxidising acids.

Hastelloy-C276 os resistant to strongly oxiding agents such as chlorine, nitric, acetic, formic, phosphoric, sulphuric and hydrofluoric acids, zinc chloride and ammonium solutions, water-based solutions containing chlorine or hypochlorites and acid solutions of ferric and cupric salts.

Hastelloy-D is exceptionally resistant  to any concentration of sulphuric acid, up to its boiling point.

CARPENTER 20 CB3

Widely used in the production of synthetic rubber, high octane gasoline (petrol), solvents, explosives, plastics, synthetic fibres, heavy chemicals, organic chemicals, pharmaceuticals and food production. in food production processes it is used to protect the end product from the risk of contamination with metallic substances.

M-50

Widely used for special ball bearings and missiles bearings components; also used for bearings in aircraft turbine motors requiring highest wear resistance up to +427°C.

TANTALIUM

Used in valves, pumps and flow meters that must be resistant to oxidising acids. it is resistant to organic chemical solutions, sea water, hydrochloric, hydrobromic and formic acids, chlorine, bromine and iodine as well as cold ammonia.

S-O HIGH-SPEED STEEL

Used in the oil industry and for off-shore drilling equipment. it is highly resistant to abrasion by pulverised rock, due to very good hardness characteristics and its highly resistant to general wear.

MATERIALS PRODUCED ON REQUEST

Special Cobalt alloys, T5 High-speed steel, InconelX625, Stellite, Elgiloy, Magnesium, Iridium, Vanadium, etc. (minimum lot requiest)