This product can indicate the wind direction in the ultimate approach and take off area and make a general indication on the wind speed. Every airport should be equipped with at least one wind cone. For the installation location, there should not be objects of obstructions nearby or airflow from the aircraft rotary wing and must be visible from the helicopter in the air.
 

Product description

ZH-9602/F Illumination Wind cone can be used as a sign in all kinds of airport to observe the wind power and wind direction in both daytime and night.  The wind sleeve is installed in a 360°bearing rotation gear, and there are two 100W metal tungsten halogen lamps on the top to provide illumination in night, and there is also a red obstruction on the upper top.
The wind sleeve is made of corrosion-resistant and high-temperature-resistant nylon flashing material.
The power supply of this product is 220V, 50Hz.
 

Components

1. Top illumination unit: two 100W tungsten halogen lamps and one red obstruction light have been installed.
2. Wind direction indication part: it includes one red-and-white wind sleeve, one wind sleeve frame and one 360°rotation gear.
3. Installation support and base part: all the supports are made of stainless steel whose bottom have a door for lead terminal.
 

Installation

Cover the wind sleeve over the wind sleeve frame and use magic tape to fix it. Check whether the wind sleeve frame is fixed stably with the rotation gear; make sure the two holding pawls of wind sleeve frame is well fixed.
Connect the wind cone as per the figure, and connect the leading wire according to the circuit requirement and check the lamp, then use 4 M16 bolts and nuts to fix the wind cone on the concrete base.
Check the verticality of installation support, and adjust it if it is oblique.
Check whether the wind sleeve can rotate well; if it is stuck, use lubricating agent (oil). Make sure to check it once every half year.
 

Technical Parameter

The support is welded by stainless steel pipe which can resist corrosion.
The whole wind cone is 1.5-7m high subject to customer’s requirement.
The illumination lamp and obstruction light is optional, and 2 100W halogen flood lamps and one 10 red obstruction light are available.
Input voltage: 220V, 50Hz (6.6A power supply method is also available according to actual requirement).

The wind sleeve has two dimensions:
1. The diameter is 300mm, the diameter at small end is 150mm and the length is 1.2m
2. The diameter is 600mm, the diameter at small end is 300mm and the length is 2.4m

The color is red-and-white or orange-and-white.
This product complies with the Consultation Announcement AC150/5345-27C and L-806 of U.S. Federal Aviation Administration (FAA), Appendix 14-Airport of International Civil Aviation Organization (ICAO) and the specifications in Part Four of Airport Design drafted by ICAO.
The max designed wind speed is 260kph.
Light wind sleeve and stainless steel wind sleeve frame.
Connect the wire in the bottom and 2.5mm2 wire terminal is available.