Archon V10P Diving Light  Operating Instructions

 

SPECIFICATIONS：

Model No.：V10P Diving Light

Bulb：LUMINUS SST40  LED(CCT 6500K)

Max brightness level：2000 lumens

Runtime：high 90min，low 150min，SOS 180min

Output levels：high> low> SOS

Reflector：glossy aluminum reflector

Lens：4mm toughened glass

Body material：durable aluminum

Angle of light beam: 16°

Surface treatment：premium anodizing

Color：Black/Red/Blue

Battery：1*21700Li-ionbatterywithBMS

With battery over-discharging protection，polarity reversing protection

Operation voltage：4.2V to 2.8V

Waterproof：up to 100 Meters

Dimensions：148mm(length)*31mm(dia. of light head)*29mm(dia. Of light body)

Weight in air：approx.280g.(without battery) ；approx.400g.(with battery)

Weight in water：approx.210g.(with battery)

 

POWER INDICATOR：

The ring-shaped power indicator surrounding the switch lights up in green，or yellow，or red，

when power capacity is above 75%，or between 75-30%，or between 30-10%.It flashes in red for power capacity between 10-5%，and switches off automatically when the power capacity is

below 5%to prevent over-discharging battery

 

BATTERY INSTALLATION：

1.Hold the light body with light head pointing upward，unscrew the head.

2.Remove used battery and replace with fresh one per polarity signs.

3.Screw light head down. Do not over tighten to break the O-ring.

 

BATTERY CHARGING：

 

1. Please connect the USB plug of the charging cable to the charging device，and its type-C plug to the battery’s charge port. The charge indicator lights in red，if the charging is in process；and it turns green after the charging is completed
2. Please keep the charging device and battery away from the flammable or explosive material. Please carry out charging under monitoring，and unplug the cable when it is finished.

 

MODES CHANGING：

Successively press the button switch to cycle through high，low，SOS，and off. And the user

may also turn it off at any light mode by long pressing the button switch for three seconds.

 

A CAUTION：

1.Please read this operating instruction carefully before the first use. Please never attempt to repair or modify the light yourself

2.Please handle illuminants with care to avoid breakage. While being hit on，illuminants can break or splinter. Splinters can cause eye and skin injuries

3.Please check the light regularly for sharp edges，scratches or damages to the surface or O-ring，as this can cause the light to flood under pressure. PLEASE LUBRICATE THE O-RING，AND REPLACE IT TIMELY.(Please avoid applying lubricant to circuit board or battery compartment cross section，which may affect the conduction.)

4.Please rinse the product surface thoroughly after each use，and allow sufficient time for it to dry both inside and outside before storage.

5.Please remove the battery from battery compartment for transport or storage.Do not lay the

battery in a fire or expose it to direct heat. Do not wet or hit the battery. Please charge it after

each use，or once every three months，to avoid over-discharging

6.Please never leave the light unattended when it is on

7.Please keep the device out of the reach of children or pets.

8.Please never shine the light to human or pet's eye.

9.It is recommended to use ARCHON battery with re/discharge protection circuit or BMS(Battery Management System) for this light.

10.In case of accidental flooding，please remove the battery，and dry the light and battery compartment as soon as possible，to prevent the secondary damage.