Diameter：250mm—2000mm

Length: up to 3500mm

The concrete is compacted during the course of the as radial pressing process. The pressing action is effected by the rotating pressing tool consisting of the distributor head, which rotates in the opposite direction of the pressing head. As a result, the torques of distributor head and pressing head largely cancel each other out, hence ensuring a precise and tension-free embedding of the reinforcement. The machine is controlled by a Siemens S7 electronics PLC (Programmable Logic Controller).the pipe production is fully automatic.

 

It is ideal for the production of

Reinforced and non-reinforced bell end pipes

Jacking pipes and rocker pipes

Pipes with two spigot ends, as well as manhole pipes, manhole rings and manhole bases

 

Special Characteristics of the RADIAL PRESS

Extremely high reliability and long life at minimal wear

Very low noise level

Extremely simple and user-friendly operation, outstanding reliability and ease of maintenance

Fully-automated production

High drive power for superior quality products, including sophisticated products like jacking pipes, thick-walled, reinforced pipes with multiple-reinforcement and the processing of difficult aggregates

The high-performance electro-hydraulic drive unit of the pressing tools replicates the typical characteristic curve of a radial press to perfection, for maximum process capacity at minimum energy consumption.