Step A-Shade Matching(Analysis)

1.Dtermine the existing shade with a Vita

Shade Guide

2.Take pre-op photos.(optional)

Step B-Preparation and Gingival Isolation

1.Place protective eye goggles on the

Step C- Teeth whitening

Dry the teeth, attach mixing tip to the dual

syringe .Apply the whitening gel to the teeth to

be whitened depending on the patient s smile

this may include 16 or more teeth in total .

Start the 1st 8-10 minutes cycle, during this operation, the customer can swallow saliva, the operator can use the aspirator for excessive saliva. This will be repeated in each cycle for a total

cycle of 3 cycles.

st

patient.

2.Polish the surface of the teeth.Then rinse

with water.

3.Apply lip protection cream to the

,

After the 1     cycle treatment, siphoning off the whitening gel on

the teeth surface, re-paint the whitening gel for customers for next cycle treatment.

Attention: before to start the next cycle treatment, the old
whitening gel must be removed by aspirator, and the new gel must

patient s lips.

4.Insert the cheek retractor into the mouth with the

tongueguard pointing down.The patient should bite down on the arms of the retractor and rest the tongue

against the tongue guard.

5.Insert the cotton rolls on either side of

mouth.Position the face-cover gauze over the

exposed areas surrounding the

mouth,securing the gauze on either side of the mouth with the

be applied.

After the third cycle treatment, siphoning off whitening gel, remove the gum protection gel, take out the anti-wet cotton roll and gauze, remove the goggles and scarf. Let the customer rinse with warm water.

Step D-   Post- treatment shade matching

Do another shade match to show the patient how much whiter

TM