1) this system can be according to customer's requirements, each nozzle tip into glue point of center distance, size can be adjusted freely, we can be flexible design, each mouth no longer set of fever circle, get rid of the fever circle and the number of sets of temperature control, the system cost is equivalent to a third of the traditional design of the hot runner cost.

2) by using two laminar type YY balance into the glue way, all the glue point is the gum at the same time, the small nozzle tip length at the same time, too much can reduce the height of the mould.

3) nozzle tip with runner plate adopts the integrated design and installation, which can realize rapid installation of a complete set of hot runner system, at the same time, all the nozzle tip can achieve the best heating effect.

4) all of the nozzle tip front runner plate and block adopts special insulation materials, can keep the whole hot runner system of temperature stability.

(5) all of the nozzle tip front-end sealant surface adopts the planar sealant, breaking the traditional front end face sealing glue, realize the rapid and exact for hot runner system installation, is not easy to find leak glue phenomenon.

6) the system has successfully applied to packaging industry products packing in PP material handle, which can realize fast injection.

7) can be applied to different common plastics and engineering plastics

8) developed by INHUI hot runner system