This 2 channel DC RF wireless remote control system can used to control lights, motor, fans, electrically operated doors/locks blinds or other appliances automatically. It is easy to install and use. The remote control switch has 2 buttons, and works with toggle, latched, momentary and momentary + toggle 4 control modes. Its control distance is about 100 meters away. It should be a good choice for you. Just take it away! Note: Customized design is acceptable, we have professional technology-support! Feature: Wireless control, easy to install Control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with AC 110~240V or DC 0~28V. You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors. With characteristics of over current protection, short-circuit protection and temperature protection. Audible / visual indication Use microcontroller model of EM78P156, an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology. Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code. One/several transmitters can control one/several receivers simultaneously. If you use two or more receivers in the same place, you can set them with different codes. Transmitting Frequency: The default frequency is 315MHz ,we can also provide 433MHz, you can leave us a message or contact us if you need. Receiver: Model No.: H2-DC12 Channel: 2 CH Control Modes: Toggle, Momentary, Latched, Momentary + Toggle Coding Type: Fixed code Coding Setting: By learning Power Supply (Operating Voltage): DC12V±1V (H2-DC12),we can also provide DC09V or DC24V,please contact us if you need. Working Voltage Range of Relay: AC 110~240V or DC 0~28V PCB size: 74mm x 52mm x 24mm Case size: 79mm x 58mm x 35mm Maximum Working Current: 10A Transmitter: Model No.: R-2 Channel: 2 CH Remote Control Distance: 100m / 300ft (theoretically) Encode: Fixed code by Soldering Unit size: 58mm x 39mm x 16mm Power Supply: 1 x 23A -12V battery (included, can be used for 12 months) Usage: Setting different control modes (We have set the receiver as Toggle control mode before delivery. If you want to use other control modes, do as following operation): Setting control mode Toggle: Only connect Jumper-2. Control mode Toggle: Press -> On; Press again -> Off. Press button A: Turn on the relay (connect B and C, disconnect A and B) Press button A again: Turn off the relay (disconnect B and C, connect A and B) Setting control mode Momentary: Only connect Jumper-1. Control mode Momentary: Press and hold -> On; Release -> Off. Press and hold button A: Turn on the relay (connect B and C, disconnect A and B) Release button A: Turn off the relay (disconnect B and C, connect A and B) Setting control mode Latched: Do not connect Jumper-1 and Jumper-2. Control mode Latched: Press -> On, another relay Off; Press another button -> Off. Press button A: Turn on the relay (connect B and C, disconnect A and B) Press button B: Turn off the relay (disconnect B and C, connect A and B) Setting control mode Momentary + Toggle: Connect Jumper-1 and Jumper-2. Control mode Momentary (Channel 1): Press -> On; Press again -> Off. Press and hold button A: Turn on relay 1 (connect B and C, disconnect A and B) Release button A: Turn off relay 1 (disconnect B and C, connect A and B) Control mode Toggle (Channel 2): Press and hold -> On; Release -> Off. Press button B: Turn on relay 2 (connect B and C, disconnect A and B) Press button B again: Turn off relay 2 (disconnect B and C, connect A and B) Package included: |