Technical parameters

Using Method

Clean and dry the surface after getting rid of the oil, dirty, rust.

Take out the cap, pierce the seal, squeeze out evenly (A:B=1:1). cover the surface with glue based on the mixing of the two components evenlywithin 3 minutes (25°C).

Press it by finger under room tempertaure according to the actual condition, it could achieve the using intensity after the solidifying for 30 minutes, it is s ested to use at -60°C~100°C.

Warning

It must be even for the mixing of the two components during the adjusting of the glue. Quantity should not excess to much.

Tighten the caps after usage .Do not mix the cap of part A and B.  

Wash off the additional glue on the hands or the surfaces of bonding materials by alcohol before its solidifying.

 
Avoid eyes and skin contact, if skin contact, wash them at once by using of a cloth with dipping of alcohol before solidifying, then, clean them by soap and warm water. If the eyes contact, wash them immediately with plenty of water, and go to a doctor if serious.

Keep out of reach of children, guard against to enter into mouth.

Storage and Packing 

Store on shady and cool place. It is available to reuse based on passing of the test if being beyond the shelf life.

 
Preserve and transport as non dangerous products.