KVW100 window module

KVW100+ Auto Window Module-(Made by Yatour)

THIS IS A ONE-TIME USE ONLY PRODUCT. THIS WILL ONLY PROGRAM ONE VEHICLE!                                 
Gross weight:80g; 
We offer this item with no packing!

Functions and Characteristics:

1. It will close all the windows(include the top window) automatically, through the upgraded car computer , after the engine is stopped and the car is locked with remote control , otherwise they will not .

2. System will keep a check on the present situation of the windows intelligently and protect the car's electric motor or storage battery. This is reflected in following two aspects:

a. If the windows have been closed before locking the door,it will not work again.

b. Some window is closed during it is working, the electric motor of the according window will be cut off.

3. The car equipped with original remote control has following tow functions:

a.  High anticlamp : the window will stop rising and fall,when it is hindered during closing the window.

b.  Dropping the window with remote control: the window can be opened with remote control outside the car (you must keep your hand pressing the unlock key),which become a part of the CANBUS system, and it does not affect any functions of the car.

4.  It is easy for any car's owner to finish the installation about in one minute without any professional knowledge.

Installation Instructions: 
For all vehicles

1.      First find your OBD-II interface plug located beneath the steering wheel under the dash.

2.      Put your key into the ignition and turn the ignition switch to "ON", there is no need to start the vehicle.

3.      Plug the KVW100 into your OBD-II interface plug. Make sure it is a snug fit. The KVW100 updates your car's CCM (Comfort Control Module) coding.The KVW100 will give a single long beep, once it is fitted properly. 

The update time is about 2 minutes. If the KVW100 gives 3 short beeps then congratulations! Your car has been updated successfully! It now has the functions of Auto Windows

4.      After the update, pull the KVW100 out from the OBD-II interface plug.

Note:
If the KVW100 gives continuous short beeps, then the update failed. You must pull it out, wait a few seconds, and then plug it into the OBD-II interface plug again. You can try up to 6 times.