Bamboo Original Image Bamboo Original Image

 

 

 

The original drawing after selection dealing area

 

the original image after selected area 

 

The image after selection area dealing

Blue for bamboo contour,it can use to measure the width and unfilled corner

of bamboo,Deep red patches

 

 

 

 

Defects can be analyzed

1.Bifurcation

2.Plaques, including the wormhole, peeling incomplete, dark spots, etc

3.distinguish the distortion

 

The defects of difficult to distinguish

Bamboo piece inside small crack, excluding the splits.

 

Requirement for equipment

As far as possible, such as bamboo interval clamping into the testing area

Position requires installation of backlight source, the height of the test about more than 1.2 m, surface about 0.3 0.5 m;

Machine speed is less than 100m per minute, s est periodic feed,every 3 seconds intosuch as feeding 20 at a time, after processing a batch of again into the next batch, the lowest cost of such equipment, life is the best.

 

 

 

Project using equipment:

1.G1TD10C Camera 3Pcs

2.High speed industrial control computer     1Pc

3.Up and down light box                   1Pc

4.Drive feeding system and completed by your company, you need to provide test signals and the camera after receiving the signal detection, testing, and the detection results in serial way transmitted to the PLC

5.PLC can design a workflow, eliminate defective bamboo stick in fixed position.