What are the working principles of emulsification machine?
Under the action of high-speed rotation of the dispersion disk, liquid and liquid-solid materials are stirred, dissolved and dispersed at high speed to complete the process of solid-liquid dispersion, wetting, depolymerization and stabilization. The speed can be adjusted arbitrarily (electromagnetic speed regulation and frequency conversion speed regulation). Speed range: 80-1250 rpm, medium speed for stirring and dissolving, high speed for dispersing and homogenizing.
Performance characteristics of mechanical lifting high-speed disperser:
1. Make the slurry flow in a rolling ring, the emulsifier produces a strong vortex, and the particles on the slurry surface spiral down to the bottom of the vortex:
2. A turbulent region is formed at the edge of the dispersion plate 2.5-5mm, and the slurry and particles are strongly sheared and impacted:
3. There is laminar flow under the dispersing disk of the dispersing machine. The slurry layers with different flow rates diffuse and play a role of dispersion.
4. The machine body can rotate at 270 degrees, and the vacuum emulsification function can better meet the multi-purpose of one machine. It can change from one cylinder to another in a very short time, which greatly improves the working efficiency.
Mechanical lifting high-speed disperser is widely used:
http://www.rayucai.com/list/?57_1.html
Coatings, dyes, inks, pigments, paper making, cosmetics, food, resins, adhesives, emulsions, pharmaceuticals, petroleum, pesticides, daily chemicals and other fields can be customized according to the specific requirements of customers. Maintenance and repair:
1. Regularly replenish lubricating oil for reducer and chain, grease for main shaft bearing and door opening bearing;
2. The chain should always be slightly tightened. Otherwise, the loose chain will easily cause the fault of jumping teeth, blade fighting, etc., resulting in unnecessary loss
3. Regularly check and supplement the lubricating oil in the oil mist eliminator of the pneumatic system, check the water collection in the air-water separator, and ensure that the water level in the tank does not exceed 80%;
4. Check whether there is air (oil) leakage in the pneumatic pipeline and interface. If there is any, replace the air pipe or plug in the connector again.
5. Check the mixer rotor regularly and remove the sundries such as braided tape and nylon thread head;
6. Always check whether there is leakage at the mixer shaft head. If there is leakage, tighten the gland bolt slightly, and replace the packing after the packing is worn out. Check the mix frequently
Check whether there is leakage at the four corners of the door opening of the closing machine. If there is leakage, adjust the support of the door arm, tighten the screws, etc. http://www.rayucai.com