Analog Peripherals
10-Bit ADC
-±1 LSB INL; no missing codes
-Programmable throughput up to 200 ksps
-Up to 17 external inputs; programmable as single-ended or differential
-Built-in temperature sensor (±3 °C)
Two Comparators
Internal Voltage Reference: 2.4 V
POR/Brown-out Detector
USB Function Controller
-USB specification 2.0 compliant
-Full-speed (12 Mbps) or low-speed (1.5 Mbps) operation
-Integrated clock recovery; no external crystal required for either full-speed or low-speed operation
-Supports eight flexible endpoints
-Dedicated 1 kB USB buffer memory
-Integrated transceiver; no external resistors required
On-Chip Debug
-On-chip debug circuitry facilitates full speed, non-intrusive in-system debug (no emulator required)
-Provides breakpoints, single stepping
-Inspect/modify memory, registers, and USB memory
-Superior performance to emulation systems using ICE-chips, target pods, and sockets
Temperature Range: –40 to +85 °C
High-Speed 8051 μC Core
-Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
-Up to 48 MIPS throughput with 48 MHz Clock
-Expanded interrupt handler
Memory
-4352 bytes data RAM (256 + 4 kB)
-64 kB Flash; in-system programmable in 512-byte sectors (512 bytes are reserved)
-External parallel data memory interface
Digital Peripherals
-40 port I/O; all are 5 V tolerant
-Hardware SMBus™ (I2C™ compatible), SPI™, and 2 UART serial ports available concurrently
-4 general-purpose 16-bit counter/timers
-Programmable 16-bit counter array with 5 capture/compare modules
Clock Sources
-Internal oscillator: 0.25% accuracy with clock recovery enabled;
supports all USB and UART modes
-External oscillator: Crystal, RC, C, or Clock
-On-chip clock multiplier: up to 48 MHz
Voltage Regulator
-On-chip voltage regulator supports USB bus-powered operation
-Regulator bypass mode supports USB self-powered operation
Operating Voltage: 2.7 to 5.25 V
Ordering Part Number
-C8051F340-GQ, 48-Pin TQFP, 9x9 mm2