Features:
* CMOS technology and fanless design. It is with stable, noiseless and vibration less performance;
* Large capacity battery. A full charged battery can be used more than 200 times continuously under 10-second-mode. Battery protection functions;
* When the battery voltage is too low or external short circuit, it will automatically cut off the output. And automatically stop charging when it is full-charged, safe and reliable.
Operation:
1. Take off the red cap from the optical fiber and then insert the metal part into the front of LED.B.(Make sure to screw the fiber to the end.)
2. To install the light hood on as show in picture 1.
3. Press the time button to choose the solidification time. 4 working time modes are available: 5, 10, 15 and 20 seconds.
4. During the operation, aim blue light at the position needing solidification.
There is a "Di" sound and the LED starts working. Then it counts down to "0" to end the solidification.
5. After the operation, please clean the fiber with calico in order not to affect the light intensity.
6. The depth of solidification of composite is no less than 4mm per 10 seconds.
7. The optical fiber can be spined off by 360° and autoclaved to high temperature of 135℃ and pressure of 0.22MPa.
8. During operation, if the indicator light of capacity is on, it means low volume, recharge it at once.

Technical Parameters:

Charge input: 110V-240V AC50-60Hz
Charge output: DC5V 2000mA
Lithium battery voltage: DC4.2V
Lithium battery capacity: 2000mAh
Output wavelength: 420-480nm
Output intensity of the light: 1400mw/cm²

E-MAIL: sales@mikatadental.com

Company Website:  http://mikatadental.com