TS NC-AUTO ROTARY DIE-CUTTING MACHINE (LEAD EDGE FEEDING)

Die-cutting department:

1. Die-cutting roller for the high quality steel material, 30mm thickness, balance correction, hard-chrome plating.
2. Wall board for high-quality cast iron material, 50mm thickness and large processing center production.
3. Soft-roll automatic grinding institutions to pouches repeat usage, grinding 3-4 times;
4. Line speed automatic compensation to ensure that each batch of cardboard boxes full of die-size line.
5. Polyurethane CUE soft pouches imports from America, easy of installation, the die-cutting 12 millions times.
6. Mechanical soft roller horizontal movement about 40mm, the pads wear uniform.
7. 40cr material the use of grinding gears for 6 levels, low noise long life.
8. Die-cutting roller cylinder automatic separation devices to reduce wear pouches.

Paper feeding department:

1. Adsorption automatic feeder, one-slotting, cut corner, creasing and drilling.
2. Feed 10,000 pieces per hour speed, precision die-cutting from +0.75mm to -0.75mm.
3. Phase planetary gear used electric adjustment, turn on and turn down were quickly adjusting.
4. Before manual adjust block cardboard side block electric adjustment.
5. Paper rollers have a plastic face, to prevent cardboard, to increase feed accuracy.

Computer unit:

1. Man-machine interfaces, PLC precision control of the entire computer system.
2. Main motor frequency control.
3. On the control panel before and after the concise, easy to operate.
4. The machine is by light, electricity, gas joint control system.
5. Electrical accessories of the machine adopt famous brands.

contact person: key.wang       skype:   key.wang95
tel:009615532771922     email:    key_mr_wang@163.com