Product Description

patch panel uses mainly for modular equipment in the central office on the front-end information management. First to enter the information point of the front-end cable (over Category 5 or Category 6 cable) into the device between the patch panel, hit the line in the patch panel module, then connect patch panels and switches with jumper (RJ45 interface) . Overall, the patch panel is used to manage the device, for example, if there is no patch panels, the front end of the information direct access to the switch, so if the cable once the problems faced to re-wiring. In addition, the management is a bit confusing, multiple plug may cause damage to the switch port. The presence of the patch panel to solve this problem, which can be achieved by replacing the jumper to better management.

Product Feature

usage and dosage) the number of network points based on the number of points of the overall network or the floor (and similar floors, it depends on the system diagram is how to design the configuration. Patch panels are different between the different buildings, different system design, the main equipment. As a building only four, the main equipment set on the first floor, all floors of the network points into the device, then the number of the patch panel on the building would be equal to all the network point / patch panel port number (24 mouth, 48, etc.), plus a certain margin; were if a building has 9 floors, the main equipment room set at 4 layer, in order to avoid the cable ultra-long each located partakers equipment and switching equipment. Patch panel between the main equipment is equal to the network layer number of points / patch panel port number (24, 48).