Product specification ( length * width * thickness ): the long 6m, the width 2m, thickness 17mm, can also be customized according to requirements.
The appearance of the product: above the turtle pattern, the trench.
Product material: natural rubber and reclaimed rubber and styrene-butadiene rubber and mineral filler material.
Product use: milk hall corridor, corridor, hall of workshop.
Product performance: high toughness, good ductility, anti-skid, anti-static, heat insulation, easy cleaning, easy replacement, anti-fatigue, epidemic characteristics. Products have no odor, treading elastic, service life of 10 years.
A, product performance: the product uses the environmental protection rubber powder and mineral filler materials, products are uniformly distributed on the surface of spherical protruding has the role of anti-skid massage. Under the surface of the friction with the ground, can eliminate sewage maintain timely drying ground. Anti-skid, anti-static, heat insulation, easy cleaning, easy replacement, anti-fatigue, epidemic characteristics. Products have no odor, collapse and flexible, durable.
Two, quality requirements, technical standards, the supplier is responsible for the quality condition and deadline
The thickness of 17mm, 65+-10 rubber plate hardness ( shore A )≥ 3.5Mpa, tensile strength, elongation at break of≥ 150%, density ≥1.2*103, kg/m3;
The service life of the product is 10 years, no health hazard in dairy cows;
Installation is firm, smooth, evenness +-10mm (i.e., detection of the 2m length range bump height of not more than 10mm );
Party B shall be responsible for the fixed installation site, in the rubber plate on both sides, along the length direction usingФ 3 rose plug fixed, spacing of 300mm, the allowable deviation of +-5mm.
Product installation method
In order to enable customers to more easily and the safe use of rubber cow mattress produced by our company, hereby provide Qingdao Guanqing Rubber Company Rubber cow mattress installation method, so as to guide the proper use.
Before the correct installation of rubber cow mattress, must take to install rubber cow mattress made of ground vertical groove is higher than the thickness of the product is at least 3 mm, smooth, clean and maintain the ground.
Qingdao Guanqing rubber Limited company produces rubber cow mattress flat according to the requirements of the site shop on the ground, one tight butt, all covered with to be laid on the ground.
Between the rubber cow mattress with a 3 cm wide and 3 mm thick stainless steel strip (with holes ) plus expansion bolt. Specifically : 6 mm ( or more) of the drill, impact drill through the rubber cow mattress using a fixed hole in the ground.
Through the rubber cow mattress, in just the punched holes inserted inside diameter of 3.5 mm ( or more), the length of not less than 4 cm plastic expansion pipe.
The plastic expansion pipe hammer tap into is laid inside the hole, and then covered with stainless steel strips, using electric drill to the appropriate type of expansion screws fixed to the plastic expansion pipe, and keep the expansion screw is not exposed outer surface rubber cow mattress.
The installation of a hole end, continue to the next.