MINI HOT MELT GLUE (CLEAR)

Model:	125M
Brand:	UEA
Origin:	Made In Taiwan, China
Category:	Chemicals / Adhesives & Sealants
Label:	MINI HOT MELT GLUE , HOT MELT , HOT MELT GLUE
Price:	-
Min. Order:	55 pc

Product Description

Identification of the product

Hot Melt Adhesive

Ingredients		CAS NO.
Ethylene-Vinyl Acetate	30 – 90%	24937 – 78 - 8
Hydrogenated hydrocarbon resin	10 – 70%	69430 – 35 - 9

Physical and Chemical Hazards / Fire and Explosive Hazards

Low Hazard	:	Material can form flammable mixtures or can burn only upon heating to the temperatures at or above the flash point.
Decomposition	:	Flammable / toxic gases will form upon decomposition.

Inhalation	:	If symptomatic, move to fresh air. Get medical attention if symptoms persist.
Skin Contact	:	Wash with soap and water. If burned by contact with molten material, cool as quickly as possible. Do not peel material from skin.
Eye Contact	:	Immediately flush eyes with large amounts of water for at least 15 minutes. Get prompt medical attention.
Ingestion	:	First aid is normally not required.

Extinguishing	:	Water spray, dry chemicals
Special Fire Precaution	:	Wear self-contained breathing apparatus and protective clothing
Hazardous Combustion Products	:	Under oxygen deficient conditions Carbon Monoxide (CO) and irritating smoke may be produced.

Sweep or scoop up and remove

Storage Temperature (°C)	:	Ambient
Transport Temperature (°C)	:	Ambient
Stirage / Transport Pressure (Kpa)	:	Atmospheric
Personal Precautionary Measures	:	No special precautionary measure should be needed under anticipated conditions of use.
Prevention of Fire and Explosion	:	Keep from contact with oxidizing materials.

Engineering Control Measures :

Local exhaust ventilation of process equipment may be needed to control aerosol exposures to below the recommended threshold exposure limit.

Personal Protection :

Where eye contact may occur, wear safety glasses with side shield.
Where skin contact may occur with hot materials, wear thermal resistant gloves, arm protection and a face shield.
Where overexposure by inhalation may occur, and engineering, work practice or other means of exposure reduction are not adequate, approve a respirators may be necessary.

Physical State	:	Solid
Form / Colour	:	Water white or opaque in colors, stick or granule in forms.
Odor	:	Odorless or resin odor
PH	:	Not applicable
Boiling Point	:	Not applicable
Specific Gravity	:	0.92 – 0.98 g/cm3
Solubility in Water	:	Negligible
Viscosity	:	8,000 – 14,000 CPS / 180°C
Flash Point	:	Over 200°C
Explosive Limit	:	Not available