Modules Strip Pre-personalization Inspection System

Product function:

※ This equipment inspect RFID antenna and calculate bad chip---M2 large module pre-personalization (40 reading heads)---M3 small module pre-personalization---Rewriting system---Punching system---Marks six stations as one, compatible with the large and small module at the same time, only need to select on the computer when switching, no need to change the mold, achieve the most simple operation, maximize the efficiency

※ Modules strip placing system

place the modules strip that need to be produced, and it move automatically

※ Inspecting RFID antenna

inspect 4/8-pin antenna of 8PIN RFID chip to identify whether the antenna is intact

※ Calculating bad chips

Calculate the Bad Chips in New Roll Module Strip to identify Bad Chip Location

※ M2 large module pre-personalization (40 reading heads)---Equipped with 40 programming stations, can write data to 40 module chips at the same time

※ M3 small module pre-personalization(40 reading heads)---Equipped with 40 programming stations, can write data to 40 module chips at the same time

※ Rewriting system

Mainly write the failed chip, the system provides rewrite function to improve the system yield.

※ Punching system A

The chip on the inner side of the module strip failed to rewrite, it will make the punching the marking at the punching system A.

※ Punching system B

The chip on the outer side of the module strip failed to rewrite, it will make the punching the marking at the punching system B.

※ Punching and marking system

For the chips fail to rewrite, it provide the function of punching or marking at the corresponding chip.

※ Modules strip roll collecting system

Collect the modules strip automatically

※ Industrial computer

Control the entire set of equipment and generate production logs

Technical parameter:

• Total 40 programming stations.
• SIEMENS PLC Control Center
• Data writing IPC
• Control IPC
• M2 Needle plate module
• M3 Needle plate module
• Two sets of bad chips punching modules, corresponding to the two chips of the module strip.
• Two sets of bad chips marking modules, corresponding to the two chips of the module strip.
• Stripe assist positioning function
• Rapid needle change mechanism, allowing less than one minute to replace the probe

Configuration:

High-speed reader, dual standard for placing and collecting modules strip

Data IPC, control IPC

PLC control system

Power: 220V(-5%~+10%),50Hz 2500W

Dimension: 2485mm×600mm×1700mm(L×W×H)

Modules strip size: thickness :0.165mm

width:35mm

length: unlimited

Air supply: 0.4Mpa/ 8L/min