Angular idlers with jack
Rack idler

Use: be used in combination with the drive jack version Part 4700/4678/4710, in cases where the two reduction gears are connected by means of the hexagonal transmission shaft Part 4680.

State of supply reduction gear box in reinforced polyamide complete with 1 gearwheel (see table for
material), 1 rack in galvanised steel with end-stop, 4 M6x55 TE UNI5739 hex head screws, 4 M6 UNI7474
self-locking nuts and 8 washers for M6 screw.
Reduction gearbox colours and nuts and bolts finish (see table).
Maintenance: not required.
Standard pack: 4 pieces.
C TECHNICAL DATA:
1 turn of the worm gear with seat for hexagonal
transmission shaft = 128mmof rack travel.
Operation: manual, if motor-driven max. 70 rpm;
max time: 1 min;
STEP BY STEP (NOcontinuous operation).
On/off ratio=1/9.