Application Range：
 

Summary

   MYHT Hydraulic Tester,researched and produced by Jinan High Land Hydraulic Pump CO.,Ltd. is a kind of practical and new type product with patent.

   In the hydraulic loop system,the acquisition of breakpoints data and the measurement of flow rate,pressure and temperature of the system and components are able to be realized simultaneously.Through the data acquried MYHT Tester evaluates the performance of the system and components and judges the faults.It is widely used in testing and diagnosing for Hydraulic Pump,Hydraulic Motor and Hydraulic valve.

MYHT-1 Series Hydraulic Tester Feature:

1. High precision-scale span ±1%

2. Turbine flow sensor-fast response,antipollution,low pressure loss

3. With fast-measuring,high-accuracy and good-stability Platinum Resistance Temperature Sensors

4. Flow and temperature display—using four LED digital tube,free of low temperature limit, Instantaneous flow rate 0.000-9999,breakpoints data keep 10 years

5. Presure indication:Seismic-resistant gauges with super stable and overload ability

6. Security design—Indicators for reverse connection of test gauges,and for pressure,power

7. Easy operation—Flow rate,pressure ang temperature can be tested simultaneously at one point.Pressure valve adjusts with light power,and the loading is smooth and quickly,accurate.To ensure the accuracy of measurement,the temperature should be kept within ±3 degrees.Low pressure gauge by pressure-measuring line can measure controlling system’s pressure

8. Wide Application-compact structure,light weight,pump test,online system test,applicable for rapid diagnosis for all kinds of mobile and fixed hydraulic system and components

Installationg and use:

     When MYHT-1 Hydraulic Tester is installed at any position of hydraulic pipe,the hydraulic oil always flows from near the loading valves to the other end.If reverse connect arises,no pressure will be formed.In order to obtain the accurate measurements,the oil inlet and oiloutlet of the tester keep away above 30cm away from the elbow,tees,valve.

Note:The loading valve must be unscrew counterclockwise before start-up of the equipment.It will cause injury or equipment damage if the loading valve is fully closed!!!!!

1)       Once the tester accessed with oil pipeline,the pressure will be regulated by Loading Valve

2)   Frigid climate will influence on the accuracy of measurement,so oil should be cycled some time before test.Until the temperature goes up to 30°C,the test shall be conducted

3)   After the completion of test,power switch should be turned off

4)   Open Pressure Loading Va n test!!!