Introduction:
1.It is a stereo Bluetooth receiver especially designed for dock station.
2.Plug this receiver into dock station,the music will be transmitted to dock station from your mobile phone which have Bluetooth stereo function.
3.It is fully plug and play and it it does not need extra power.

Connecting receiver to  the dock station:
1.Turn on the dock station before pl ing the receiver.
2.Then set the audio source to mobile.
3.Finally plug the  receiver into the 30-pin connector port and the receiver will start to flash blue and red alternately .


Operation Steps:
1.Bluetooth music receiver connects directly to iPod speaker 30-pin dock, and then the red LED lamp and the blue LED lamp will flicker alternately until they enter paring mode, which means the device starts to work normally. Perform bluetooth paring operations after it is on for 30 seconds.
2.After it enters paring mode, enable the bluetooth function for the devices such as iPad, iPhone, bluetooth PC, cell phone and any other digital products with bluetooth function. Search bluetooth devices or new devices to find      I-WAVE and connect it. Password input for paring is needed, and the default password is: 0000. 
3.After successful paring, the red LED lamp will turn off and the blue LED lamp will flicker slowly, which means it has been connected already. Then we can play music by player. 
4.To change the play device during normal operation, disconnect the connected bluetooth PC and cell phone, and then perform paring connection for other bluetooth devices.