2-wire zc102c smoke detector compatible with all conventional fire alarm control panel

Dual LEDs-two LEDs blink standby,provide 360degree visibility

Unique optical sensing chamber-Engineered to sense smoke by a wide range of combustion sources.

Unpolarized wire input-to prevent the likelihood of wiring errors.

General Description

The device is photoelectronic detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with most conventional fire alarm control panel.

Two LEDs on each detector provide local 360degree visible alarm indication. they flash every 3~5seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. the detector can be reset only by a momentary power interruption. 

Technical Specifications

System voltage: 24VDC(9~28VDC)

Standby current:120uA@24VDC

Alarm current:20mA@24VDC

Operating temperature range: -10C to 50C

Operating humidity range: 10% to 93% relative humidity.Noncondensing

Latching Alarm: Reset by momentary power interruption

Size:99x99x48mm

Weight:155g

Installation Guidelines

All wiring must be installed in compliance with the National Electrical code,applicable state and local codes,and any special requirements of the local Authority having jurisdiction.