Multifunction emergency warning light is a new type of car products, this product free of wiring, maintenance free, the internal products are solar charging module and a lithium battery electric storage device, driving automatic warning function, open the light for the safety of driving at night very good assisted effect.

1.Solar charging, lithium battery battery, no wiring, maintenance free, and efficient environmental protection

2.14 highlight LED order, length is 210 mm, many kinds of flash mode, the warning effect is very obvious, very good auxiliary effect for driving safety.

3.Flexible and simple to install, just put the product attached sucker adsorption in the inside of the windscreen

4.Intelligent control system, with high sensitivity and photographic system, vibration sensor in driving while under the environment of dark shine on its own.And delay shutdown functions, such as parking and continue to work in the progress of the red light, stop body no vibration or shut down automatically after 120 seconds;

5.Car drivers to take care of function, after close to 10 meters range, multi-function alarm will automatically stop, after overtaking or distance warning lights start flashing

The main features of products

Security, traffic warning, prevent collision functions, product built-in high vibration sensor sensitivity, criminals slight touch body at night, lights products warning function automatically open, can cause people attention, play the role of frighten criminals.14 LED lights products order, length 210 mm, many kinds of flash mode, installed on the inside front and back windscreen, driving at night can remind on the vehicle, to warn the rear vehicle, prevent rear-end accident, etc

product installation procedure

Adsorbed on the inside of the front and back windscreen, warning lights can also be installed in car front and rear bumpers fixed license plate location. When installation to wipe clean surface adsorption position first, and then will be chuck dipped in the water a little sticker, so we can get the stronger adhesion

Lights flashing mode

Warning lights use 14 highlight LED lamp order, direct flash - pulled at - reverse flash - scan and so on the many kinds of flashing mode, each mode keep 3 seconds, and 15 seconds to complete a cycle, such as can not use lamp switch 

Specification

Size:20CM*2.7CM

Voltage:12V

power consumption:14W