Wire and cable wire connector detector

1. USES:

Through the detection signal as online system for cable joint production line detected and prevent the connector is used with.

Cable connector have solder, pressure welding, the welding wire is used to mix, this joint and normal wire material and shape a little different, the differences with the principle of the eddy current loss to check it out.

Special function of the detector, is based on readings and normal wire connector, according to the values of the bar code on the LED can clear and reliable display is given.

2. Parameters: / function

Detection sensitivity: continuous variables

The sensitivity setting knob: detection sensitivity can be set freely.

Check out the indicator light: red leds

Detection display: 12 3 color barcode LED and three green, 7 segment LED

Display mode: instantaneous value monitoring mode and peak holding mode

Alarm output: 0.5 seconds once the output is not greater than 1 a load

Alarm output cumulative displays (zero)

3. Type:

DX - 10 6 kinds of detectors, DX - 14, DX - 20, 30, DX - DX - 50, DX - 100

DX - 10 (below apply to: Φ 5 mm)

DX - 14 (below apply: Φ 8 mm)

DX - 20 (below apply: Φ 12 mm)

DX - 30 (below apply: Φ 20 mm)

DX - 50 (applies: Φ below 35 mm)

DX - 100 (applies: Φ below 80 mm)