HSD ISO30 ER32 Tool Holders with Covernut and Retainer Knob

 

Description:

This is a balanced ISO 30 tool holder (cone) that is used for ISO 30 taper systems. All HSD ISO 30 ATC spindles use this cone. The HSD Auto Tool Changer clamping system uses the pull stud at the end to pull the cone precisely into the spindle’s taper.

 

ISO30 ER32 Toolholder, A=50mm. Commonly known as ISO30 for many HSD equipped CNC routers. Balanced to 30,000 rpm ≦G2.5, includes HSD pull stud and ER32 collet nut. 

 

Features:

Collet Chuck accepts all ER32 collets

Works on all machines that take ISO30 tooling

All critical surfaces precision ground

Made from alloy steel hardened to 54 - 56rc

Balanced to 30,000 rpms

Concentricity is less than .0001 at collet face

Rear thread for pull stud for HSD ATC spindle

Gage length is 42mm

Tool holder model: ISO30ER32-42

Application: ATC cnc center /cnc router/cnc woodworking engraving machine

 

HSD ISO30 ER32 Tool Holder with Retention Knobs and covernut

  

Covernuts are used to hold and clamp tools into a spindle. Spindles operate at speeds up to 24,000 RPM so it is vital that balanced covernuts are used. Tool holders (also called “Cones”) are used in ATC style systems. All tool holders and covernuts on this website are balanced.

Using unbalanced covernuts or tool holders will damage the spindle.

Correct installation of the collet and tool is required to avoid damaging tooling, cones, and spindles. 

 

More model ISO30 tool holders: 
 

Model NO	Tool holding Capacity (mm)	Diameter of Clamping Nut	Collet	Wrench
ISO30-ER16-60M/MS	0.5-10	22	ER16	ER16
ISO30-ER20-60M/MS	1-13	28	ER20	ER20
ISO30-ER25-60	1-13	42	ER25	ER25
ISO30-ER32-42	2-20	50	ER32	ER32
ISO30-ER32-60	2-20	50	ER32	ER32
ISO30-OZ25-60	3-25	60	OZ-25	OZ-25
SK30-ER40-60	4-26	63	ER40	ER40

Nut and Pull Stud is Included

Collets Not Included-Click Here for Collet Selections