GRIP-G

The safe and light weight pipe connection

“Pull-out” resistant pipe connections made from all stainless steel. The GRIP-G  is the light range from GRIP. It is suitable for all applications in shipbuilding and offshore industries. The particular advantages of the GRIP-G are its low weight and its single-bolt systemfor the small-diameter couplings.

• For all marine pipe systems, essential and non essential, DNV/GL AND CCS tested

• Also reliably joins CuNiFe, duplex or titanium pipe materials

• Absorbs stresses in the pipe system and during operation

• Minimal bolt torque to optimise lifespan of seal

• Simple and fast assembly thus reduce installation time

• Separate independent anchoring and sealing mechanisms

Operating pressure in shipbuilding: 16 bar

Diameters: 26.9 to 406.4 mm

Temperature range: -20° C to 100° C

Order example: GRIP-G 76.1, EPDM

 

Our quality products – your benefit

The results of various endurance tests and inspections prove it and our customers’ satisfaction around the whole world reflects it every single day – GRIP pipe couplings can be trusted. They offer immense customer benefit, convince through practice-tested safety and consequent cost-effectiveness.

System independence: Connects the most varied pipe materials

Flexible pipe connection: Stress-free, compensates for tolerances

Easy assembly: Light, space-saving, no pipe-end preparation

Safe assembly without risk of fire or explosion: No protective measures required

Damping characteristics: Noise, vibration, movement

Economical: Cost-saving thanks to short assembly times

Progressive sealing effect

If the pressure in the pipe rises, the contact pressure on the sealing lips also

increases due to the flow through the pressure equalization channel.

Progressive anchoring effect

If the axial tensile load on the pipe rises due to increased internal pressure or

external influence, the teeth continuously penetrate deeper into the surface of

the pipe to compensate.

 

Component

Housing with bridge	AISI304, AISI316L, AISI316TI
Housing bridge	AISI304, AISI316L, AISI316TI
Anchoring ring	AISI301
locking trunnions	AISI304, AISI316L, AISI316TI
Locking bolts	AISI304, AISI316L, AISI316TI
Washer	AISI304, AISI316L, AISI316TI
Sealing sleeve	EPDM, NBR, MVQ, VITON

Sealing sleeves: Areas of application & temperature resistance

Material of seal	EPDM	NBR
Temperature range	–30 oC up to +125 oC OD 26.9 up to 168,3 mm –20 oC up to +80 oC OD > 180 mm	–20 oC up to +80 oC
Media	Drinking water Alcohols Compressed air	Solids   Water   Oils Gases (combustible)   Fuels Hydrocarbon solutions